Poulan 96012008800, 425182 manual Tractor, Blade Removal See Fig, Check Operator Presence System

Page 16

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments sec- tion of this manual).

TIRES

•Maintain proper air pressure in all tires (See the side of the tire for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot

and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

828

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Useonlyareplacementblade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 8)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

BLADE

STAR

 

 

02545

 

MANDREL

 

ASSEMBLY

BLADE BOLT

CENTER

(SPECIAL)

HOLE

FIG. 8

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents PO18542LT ModelGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Contents of Hardware Pack Tools Required for Assembly To Remove Tractor from CartonBefore Removing Tractor from Skid Unpack CartonCheck Battery See Fig Check Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate Mower See FigTo Operate on Hills To TransportBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Maintenance Schedule Lubrication ChartGeneral Recommendations Before Each USETractor Blade Removal See FigCheck Operator Presence System Check Reverse Operation ROS SystemBattery EngineBelts Transaxle CoolingCleaning Clean AIR ScreenAIR Filter MufflerTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing FRONT-TO-BACK Adjustment See FigsBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTransaxle Gear Shift Lever NEUTRAL- Adjustment See Fig To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbOther Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty PoulanService Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés MAX Dentretien Notes Limitée Garantie Dépannage DE Guide Défectueux estRalenti Entreposage MoteurRéglages ET Révision MoteurCarrossage AVANT/ Roues DES Convergence Tionrec -DI LA DE L’ALIGNEMENT Régler Pour19 .Fig Chan DE Levier DU Neutre AU Réglage’EN Courroie LA Remplacer Pour Fig la VoirCourroie Acer Rempl Pour DE Boîtier LE Niveau DE Mettre Pour SedeutonFig la Voir Tondeuse LA Installer Pour Reglages ET RevisionTracteur Tondeuse LA Enlever PourEntretien Transmission LA DE Refroidissement LubrificationTrapézoïdales Courroies 10 .FIGFig la Voir Lame LA Enlever EN Fonctionnement DE Système ETRecommandations LES GénéralesLubrification DE Tableau Utilisation Chaque AvantUtilisation Tonte DE ConseilsMoteur LE Démarrer DE Avant Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierAccessoires Autres ET Charrettes DES Remorquer PourTracteur LE Transporter Pour Pentes LES Dans Utiliser PourGAZ DES Commande LA Utiliser Pour T O S I L I T UTeurtrac Reculer Pour ET Avancer Pour02829 Moteur Montage Correctement Sont Courroies LESToutes SI Vérifier Toutes SI Vérifier NI DE EST Tondeuse LA SI VérifierDesmancom des fonction la et Fig la Voir Batterie LA VérifierPalet LA DE Tracteur LE Retirer Pour DU Tracteur LE Sortir Pour LE Pour Exigés Outils LESPalette LA ToncarMontar SIN Piezas Client DU Responsabilités SommaireProduit DE Spécifications Entretien RemorquageEnfants Général EntretienPentes LES Dans FonctionnementGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé

96012008800, 425182 specifications

The Poulan 425182,96012008800 is a highly regarded handheld leaf blower that serves the needs of both homeowners and professionals seeking efficient yard cleanup solutions. Known for its lightweight design and user-friendly features, this leaf blower is designed to make yard work less of a chore while enhancing productivity.

One of the standout features of the Poulan 425182 is its powerful engine. Equipped with a robust 25cc two-stroke engine, it delivers impressive airflow and speed, allowing users to tackle even the most stubborn leaves and debris with ease. The engine is designed for efficient fuel consumption, which means longer run times and less frequent refueling, a crucial factor for those tackling larger yards or extended jobs.

The ergonomic design of the Poulan 425182 means that it is comfortable to hold and operate for extended periods. Weighing in at just under ten pounds, it reduces user fatigue and allows for better maneuverability while working. This is particularly beneficial for those looking to clear large areas or navigate around obstacles like flower beds, trees, and outdoor furniture.

Another significant aspect of the Poulan 425182 is its variable speed control. This feature enables users to adjust the blower's power to suit the specific job at hand, whether it's light debris around flower beds or heavy leaf accumulation in corners of the yard. The variable speed not only enhances efficiency but also contributes to more precise cleaning.

The blower also incorporates a convenient cruise control feature that allows users to maintain a consistent airflow without needing to keep their finger on the throttle trigger. This adds to user comfort and provides a more enjoyable experience during lengthy tasks.

In terms of maintenance, the Poulan 425182 offers easy access to air filters and spark plugs, making it simpler to perform routine checks and ensure optimal performance. The two-stroke engine simplifies fuel mixing, and the reduced emissions technology helps to minimize environmental impact while still delivering the power needed for effective yard care.

In summary, the Poulan 425182,96012008800 leaf blower is a reliable tool that combines power, efficiency, and ease of use. Its lightweight design, ergonomic features, variable speed control, and low emissions technology make it a top choice for anyone looking to maintain their outdoor spaces effortlessly. For versatile and effective yard cleanup, this leaf blower stands out in the competitive market of outdoor power equipment.
Top Page Image Contents