Poulan 301ZX warranty Winter Storage, Service

Page 45

STORAGE

Winter Storage

The machine should be readied for storage at the end of the mowing season, or if it will not be in use for longer than 30 days. Fuel allowed to stand for long periods of time (30 days or more) can leave sticky residues that can plug the carburetor and disrupt engine function.

Fuel stabilizers are an acceptable option as regards to the sticky residues that can occur during storage.

Add stabilizer to the fuel in the tank or in the storage container. Always use the mixing ratios specified by the manufacturer of the stabilizer. Run the engine for at least 10 minutes after adding the stabilizer so that it reaches the carburetor. Do not empty the fuel tank and the carburetor if you have added stabilizer.

WARNING!

Never store an engine with fuel in the tank indoors or in poorly ventilated spaces where fuel vapor can come in contact with open flames, sparks, or a pilot light such as in a boiler, hot water tank, clothes drier, etc. Handle the fuel with care. It is very flammable and can cause serious personal injury and property damage. Drain the fuel into an approved container outdoors and store far away from open flame. Never use gasoline for cleaning. Use a degreaser and warm water instead.

To ready the machine for storage, follow these steps:

1.Thoroughly clean the machine, especially under the mower deck. Touch up damage to the paint and spray a thin layer of oil on the underside of the mower deck to avoid corrosion.

2.Inspect the machine for worn or damaged parts and tighten any nuts or screws that may have become loose.

3.Change the engine oil; dispose of properly.

4.Empty the fuel tanks or add a fuel stabilizer. Start the engine and allow it to run until the carburetor is drained of fuel or the stabilizer has reached the carburetor.

5.Remove the spark plug and pour about a tablespoon of engine oil into the cylinder. Turn over the engine so that the oil is evenly distributed and then refit the spark plug.

6.Lubricate all grease zerks, joints, and axles.

7.Remove the battery. Clean, charge, and store the battery in a cool place, but protect it from direct cold.

8.Store the machine in a clean, dry place and cover it for extra protection.

Service

When ordering spare parts, please specify the purchase year, model, type, and serial number.

Always use genuine Poulan spare parts.

An annual checkup at an authorized service workshop is a good way to ensure that the machine performs its best the following season.

45

Image 45 Contents
Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentKeep children away from work area Safe Handling of Gasoline General Maintenance Risk of sparking Spark Arrestor TransportControl Locations ControlsSteering Control Levers Ignition Switch Parking BrakeThrottle Control Fuel Tank Choke ControlMower Deck Lifting Lever Fuel Shut Off ValveTracking Always use the high position F to transportBypass Linkage Blade Control LeverOperation TrainingSteering Starting the Engine Before StartingPlace controls in neutral position Open the fuel valve Weak Battery Jumper cablesTo remove cables, reverse order Running Operating on Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Schedule Maintenance100 300 Year Battery Cleaning battery and terminalsAlways use protective glasses when handling the battery Tire Pressures Safety SystemDeck Belt Replacement BeltsDeck Belt Cutting Blades EZT BeltLeveling Deck Adjusting the Mower DeckRemoval and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster Wheels General LubricationFront Wheel Bearings Front Wheel MountDeck Spindle TransmissionProblem Cause TroubleshootingTroubleshooting Service StorageWinter Storage Schematic Technical Data Torque SpecificationsStandard Hardware Engine Overall dimensionsTransmission EquipmentUSA Requirements Conformity CertificatesDelivery Service Service JournalAfter 5-10 Hours Hour ServicePerform the 25-hour service At Least Once Each Year Service Journal
Related manuals
Manual 24 pages 51.72 Kb