Poulan 191603 manual Service And Adjustments, To Remove Mower, To Install Mower, Tractor

Page 20
SERVICE AND ADJUSTMENTS

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER- VICE OR ADJUSTMENTS:

1.Depress clutch/brake pedal fully and set parking brake.

2.Place gearshift lever in neutral (N) position.

3.Place attachment clutch in “DISENGAGED” position.

4.Turn ignition key to “STOP” and remove key.

5.Make sure the blades and all moving parts have completely stopped.

6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER

Mower will be easier to remove from the right side of tractor.

1.Place attachment clutch in “DISEN- GAGED” position.

2.Move attachment lift lever forward to lower mower to its lowest position.

3.Roll belt off engine pulley.

4.Remove small retainer spring, and remove clutch spring off pulley bolt.

5.Remove large retainer spring, slide collar off and push housing guide out of bracket.

6.Disconnect anti-sway bar from chassis bracket by removing retainer spring.

7.Disconnect suspension arms from rear deck brackets by removing retainer springs.

8.Disconnect front links from deck by removing retainer springs.

9.Raise lift lever to raise suspension arms. Slide mower out from under trac- tor.

IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook the clutch spring Into square hole in frame.

TO INSTALL MOWER

1.Raise attachment lift lever to its highest position.

2.Slide mower under tractor with deflec- tor shield to right side of tractor.

3.Lower lift lever to its lowest position.

4.Connect front links to mower deck and secure with retainer springs.

5.Connect suspension arms to rear deck brackets and secure with retainer springs.

6.Connect anti-sway bar to chassis bracket and secure with retainer spring.

7.Push clutch cable housing guide into bracket, slide collar onto guide and secure with large retainer spring.

8.Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.

9.Install belt onto engine pulley.

Flat Washer

Small Retainer Spring

 

 

Clutch Spring

 

 

Small Retainer Spring

 

Square Hole

Suspension

 

Clutch Spring

 

Arms

Engine Pulley

Retainer Spring

 

Front Link

 

 

Anti-Sway Bar

 

Retainer Springs

Collar

 

 

(Both Sides)

 

 

Deflector

 

 

Shield

Housing Guide

Large Retainer

Bracket

 

 

Spring

 

 

20

Image 20
Contents Assembly Operation Maintenance Service and Adjustments Storage Troubleshooting Repair PartsMODEL NO. CN1842STA 18.0 HP 42 INCH LAWN TRACTORLIMITED WARRANTY TABLE OF CONTENTSWARRANTY SAFETY RULES I. GENERAL OPERATIONII. SLOPE OPERATION Wash hands after handlingDO NOT IV. SERVICEIII. CHILDREN SAFETY RULES PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIESUNASSEMBLED PARTS Steering WheelSlope Sheet KeysASSEMBLY/PRE-OPERATION TOOLS REQUIRED FOR ASSEMBLYHOW TO SET UP YOUR TRACTOR INSTALL SEATCHECK BATTERY INSTALL MULCHER PLATE If previously removed CHECKLISTTO CONVERT TO BAGGING OR DISCHARGING CHECK TIRE PRESSUREOPERATION LIGHT SWITCH POSITION - Turns the headlights on and off KNOW YOUR TRACTORHOW TO USE YOUR TRACTOR TO ADJUST MOWER CUTTING HEIGHTENGINE TO SET PARKING BRAKEBEFORE STARTING THE ENGINE TO OPERATE MOWERTO OPERATE ON HILLS TO TRANSPORTTO START ENGINE MOWING TIPSBEFORE EACH USE MAINTENANCEGENERAL RECOMMENDATIONS BATTERY TRACTORBRAKE OPERATION TIRESCLEAN AIR SCREEN ENGINETRANSAXLE COOLING V-BELTSCLEANING MUFFLERSPARK PLUGS IN-LINE FUEL FILTERTO REMOVE MOWER SERVICE AND ADJUSTMENTSTO INSTALL MOWER TO LEVEL MOWER HOUSING TO CHECK AND ADJUST BRAKE TO REPLACE MOWER BLADE DRIVE BELTTO REPLACE MOTION DRIVE BELT With parking brake “Engaged”TO ADJUST STEERING WHEEL ALIGN- MENT TO START ENGINE WITH A WEAK BATTERYFRONT WHEEL TOE-IN/CAMBER TO REMOVE WHEEL FOR REPAIRSTO ADJUST CARBURETOR REPLACING BATTERYTO ADJUST THROTTLE CONTROL CABLE TO REPLACE HEADLIGHT BULBBATTERY STORAGEOTHER FUEL SYSTEMTROUBLESHOOTING CHART PROBLEMLoss of power CAUSEto run when oper continuedExcessive vibrationBattery will not when turningPoor grass dischargeSUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION FOLDALONG THIS