ASSEMBLY
INSTALL SEAT (See Figs. 3 and 4)
•Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard.
•Connect switch to seat.
•Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.
SEAT |
SWITCH |
PAD |
SLOT |
SEAT |
PAN |
TAPE |
WIRING HARNESS |
Fig. 3
•Push down on seat to engage pads in slots and pull seat towards rear of tractor.
•Raise seat and tighten bolt securely.
•Remove tape and discard.
•Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.
SLOT |
| TAPE | |
PAD |
|
| |
FLAT |
|
| |
WASHER |
|
| |
SEAT PAN |
| ||
BOLT | TAB | ADJUSTMENT | |
HANDLE | |||
|
|
Fig. 4
NOTE: You may now roll your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)
•Raise attachment lift lever to its highest position.
•Releaseparkingbrakebydepressingclutch/brakepedal.
•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).
•Roll tractor forward off skid.
•Remove banding holding the deflector shield up against tractor.
7