Infinity HTS-20 owner manual WALL-MOUNTING the Satellites, Vertical Mounting Using Bracket

NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers.

VERTICAL MOUNTING...

Figure 5. This illustration shows how to mount the speaker vertically on a wall or ceiling four different ways.

WALL-MOUNTING THE SATELLITES

The satellite speakers can be wall- or ceiling-mounted, as shown in Figures 5 and 6. You can mount the speakers with #6 wood screws (not included), using the built-in mounting bracket.

Use the enclosed template to mark the desired position of each speaker on a wall or ceiling. Locate a stud for secure mounting and use heavy-duty wood screws with long threads. Test the mounting thoroughly before installation.

To mount the speaker vertically on a wall, fasten the wood screws (not included) to a wall stud, leaving a 3 ⁄16" clearance between the base of the screw head and the wall. If desired, loosen the bracket screw, adjust the bracket angle, and tighten the bracket screw.

NOTE: You may want to route the wires before tightening the bracket screw (see Figure 8 on page 11).

Then orient the speaker vertically, align the crossholes on the rear of the speaker with the wood screws, and slide the speaker down.

VERTICAL MOUNTING USING BRACKET

(rear view)

❶ Loosen Screw	3/16"
❷ Rotate Bracket
	wall
❸ Tighten Screw	wood
	screw
Screw	(side view)
(inside hole)
Slide Speaker Down	#6 Wood Screws
Onto Wood Screws	(fasten to wall stud)

Positions

(top view)

20° From Wall	45° From Wall	67.5° From Wall	90° From Wall
(Bracket Closed)	(Bracket Open,	(Bracket Open,	(Bracket Open,
	Position #1)	Position #2)	Position #3)

HTS-20 Home-Theater System – Owner’s Manual ◆ 9