Poulan XT24H42LT manual Troubleshooting Points, Problem Cause Correction

Page 25

TROUBLESHOOTING POINTS

PROBLEM

 

CAUSE

 

CORRECTION

 

 

 

 

 

 

 

 

 

 

 

 

 

Will not start

 

1.

Out of fuel.

 

1.

Fill fuel tank.

 

 

 

 

2.

Engine not “CHOKED” properly.

 

2.

See “TO START ENGINE” in Operation section.

 

 

 

 

3.

Engine flooded.

 

3.

Wait several minutes before attempting to start.

 

 

 

 

4.

Bad spark plug.

 

4.

Replace spark plug.

 

 

 

 

5.

Dirty air filter.

 

5.

Clean/replace air filter.

 

 

 

 

6.

Dirty fuel filter.

 

6.

Replace fuel filter.

 

 

 

 

7.

Water in fuel.

 

7.

Empty fuel tank and carburetor, refill tank with fresh

 

 

 

 

 

 

 

 

gasoline and replace fuel filter.

 

 

 

 

8.

Loose or damaged wiring.

 

8.

Check all wiring.

 

 

 

 

9.

Carburetor out of adjustment.

 

9.

See “To Adjust Carburetor” in Service Adjustments

 

 

 

 

 

 

 

 

section.

 

 

 

 

10.

Engine valves out of adjustment.

 

10.

Contact an authorized service center/department.

 

 

 

 

 

 

 

 

 

 

Hard to start

 

1.

Dirty air filter.

 

1.

Clean/replace air filter.

 

 

 

 

2.

Bad spark plug.

 

2.

Replace spark plug.

 

 

 

 

3.

Weak or dead battery.

 

3.

Recharge or replace battery.

 

 

 

 

4.

Dirty fuel filter.

 

4.

Replace fuel filter.

 

 

 

 

5.

Stale or dirty fuel.

 

5.

Empty fuel tank and refill tank with fresh, clean gasoline.

 

 

 

 

6.

Loose or damaged wiring.

 

6.

Check all wiring.

 

 

 

 

7.

Carburetor out of adjustment.

 

7.

See “To Adjust Carburetor” in Service Adjustments

 

 

 

 

 

 

 

 

section.

 

 

 

 

8.

Engine valves out of adjustment.

 

8.

Contact an authorized service center/department.

 

 

 

 

 

 

 

 

 

 

Engine will not turn over

 

1.

Brake pedal not depressed.

 

1.

Depress brake pedal.

 

 

 

 

2.

Attachment clutch is engaged.

 

2.

Disengage attachment clutch.

 

 

 

 

3.

Weak or dead battery.

 

3.

Recharge or replace battery.

 

 

 

 

4.

Blown fuse.

 

4.

Replace fuse.

 

 

 

 

5.

Corroded battery terminals.

 

5.

Clean battery terminals.

 

 

 

 

6.

Loose or damaged wiring.

 

6.

Check all wiring.

 

 

 

 

7.

Faulty ignition switch.

 

7.

Check/replace ignition switch.

 

 

 

 

8.

Faulty solenoid or starter.

 

8.

Check/replace solenoid or starter.

 

 

 

 

9.

Faulty operator presence switch(es).

 

9.

Contact an authorized service center/department.

 

 

 

 

 

 

 

 

 

 

Engine clicks but will not

 

1.

Weak or dead battery.

 

1.

Recharge or replace battery.

 

start

 

2.

Corroded battery terminals.

 

2.

Clean battery terminals.

 

 

 

 

3.

Loose or damaged wiring.

 

3.

Check all wiring.

 

 

 

 

4.

Faulty solenoid or starter.

 

4.

Check/replace solenoid or starter.

 

 

 

 

 

 

 

 

 

 

Loss of power

 

1.

Cutting too much grass/too fast.

 

1.

Raise cutting height/reduce speed.

 

 

 

 

2.

Throttle in “CHOKE” position.

 

2.

Adjust throttle control.

 

 

 

 

3.

Build-up of grass, leaves and trash under mower.

 

3.

Clean underside of mower housing.

 

 

 

 

4.

Dirty air filter.

 

4.

Clean/replace air filter.

 

 

 

 

5.

Low oil level/dirty oil.

 

5.

Check oil level/change oil.

 

 

 

 

6.

Faulty spark plug.

 

6.

Clean and regap or change spark plug.

 

 

 

 

7.

Dirty fuel filter.

 

7.

Replace fuel filter.

 

 

 

 

8.

Stale or dirty fuel.

 

8.

Empty fuel tank and refill tank with fresh, clean gasoline.

 

 

 

 

9.

Water in fuel.

 

9.

Empty fuel tank and carburetor, refill tank with fresh

 

 

 

 

 

 

 

 

gasoline and replace fuel filter.

 

 

 

 

10.

Spark plug wire loose.

 

10.

Connect and tighten spark plug wire.

 

 

 

 

11.

Dirty engine air screen/fins.

 

11.

Clean engine air screen/fins.

 

 

 

 

12.

Dirty/clogged muffler.

 

12.

Clean/replace muffler.

 

 

 

 

13.

Loose or damaged wiring.

 

13.

Check all wiring.

 

 

 

 

14.

Carburetor out of adjustment.

 

14.

See “To Adjust Carburetor” in Service Adjustments

 

 

 

 

 

 

 

 

section.

 

 

 

 

15.

Engine valves out of adjustment.

 

15.

Contact an authorized service center/department.

 

 

 

 

 

 

 

 

 

 

Excessive vibration

 

1.

Worn, bent or loose blade.

 

1.

Replace blade. Tighten blade bolt.

 

 

 

 

2.

Bent blade mandrel.

 

2.

Replace blade mandrel.

 

 

 

 

3.

Loose/damaged part(s).

 

3.

Tighten loose part(s). Replace damaged parts.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

25

Image 25
Contents Always Wear EYE Protection During Operation XT24H42LTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Steering Wheel Gauge Wheels Unassembled PartsSeat Key Slope SheetTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Tire Pressure Assemble Gauge Wheels to Mower Deck See FigCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsAutomatic Transmission Warm UP Lubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine Cleaning To Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust BrakeSee Fig To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight Bulb Interlocks and RelaysOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Limited Warranty Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service