Poulan 178249 owner manual Service and Adjustments, To Remove Mower See Fig, To Install Mower

Page 21

SERVICE AND ADJUSTMENTS

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key “OFF” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 22)

•Place attachment clutch in “DISENGAGED” position.

•Turn height adjustment knob to lowest setting.

•Lower mower to its lowest position.

•Remove retainer spring holding anti-swaybar to chassis bracket and disengage anti-swaybar from bracket.

•Remove retainer springs from suspension arms at deck and disengage arms from deck.

•Raise attachment lift to its highest position.

•Remove two retainer springs from each front link and remove links.

•Slide mower forward and remove belt from electric clutch pulley.

•Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual.

TO LEVEL MOWER HOUSING

SIDE-TO-SIDE ADJUSTMENT (See Figs. 23 and 24)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Three full turns of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

BOTTOM EDGE

OF MOWER TO

OF MOWER TO

GROUND

GROUND

A

A

 

GROUND LINE

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PRODUCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

ADJUSTMENT

FRONT MOWER

NUTS

BRACKET

 

SUSPENSION

LIFT

ARMS

LINKS

CHASSIS

BRACKET

FIG. 23

SUSPENSION ARM

LIFT LINK ADJUSTMENT NUT

FIG. 24

FRONT

LINKS

RETAINER

SPRINGS

RETAINER

FRONT MOWER

SPRING

BRACKET

ANTI-SWAY

BARRETAINER

SPRINGS

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents DPR22H46STB Safe Operation Practices for Ride-On Mowers IV. ServiceGeneral Operation II. Slope OperationSafety Rules Table of Contents Unassembled Parts Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonTo Attach Nose Roller See Fig Install Seat See FigTo Install Mulcher Plate See Fig To SET UP Your Mower for Mulching See FigAssemble Gauge Wheels to Mower Deck See Fig To Convert to Bagging or DischargingInstall Mower and Drive Belt See Figs Check Mower Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelADD Gasoline To Start Engine See FigPurge Transmission Mulching Mowing Tips Mowing TipsCustomer Responsibilities Lubrication ChartGeneral Recommendations Before Each USETractor Engine Muffler CleaningSpark Plugs Engine OIL FilterTo Install Mower Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig To Replace Mower Drive BeltTo Adjust Brake See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel Alignment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Hood and Grill Assembly See Fig Replacing Battery See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigTo Adjust Carburetor Other StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsOFF Service Notes Tractor Model Number DPR22H46STB SchematicElectrical 17720408 178450178861 Chassis and Enclosures 174997 174619175582 175692X428Drive 178289 17541772140608 175456Steering Assembly 177883 175121155105 175146Spark Arrester Engine164067 Control Throttle 148315Seat Assembly Wheels & Tires Decals178249 178250Mower Lift Mower Deck 19131312 17608474780616 175746Limited Warranty Sighting Guide Suggested Guide for Sighting Slopes for Safe OperationParts and Service

178249 specifications

The Poulan 178249 is a robust and versatile chainsaw designed for both professional and residential use. Renowned for its reliability and efficiency, this model stands out in the competitive market of outdoor power tools. One of the main features of the Poulan 178249 is its powerful 18-inch bar and chain, which allows users to tackle a wide range of cutting tasks, from firewood preparation to tree trimming.

Equipped with a 42cc 2-cycle engine, the Poulan 178249 provides ample power while maintaining a manageable weight, making it easier to handle for extended periods. The lightweight design is coupled with an ergonomic handle that offers comfort and control, reducing strain on the user’s hands and arms during operation. This makes the chainsaw particularly suitable for both seasoned professionals and occasional users.

One of the standout technologies in the Poulan 178249 is its Easy Start system, which significantly reduces the effort needed to start the engine. This feature is especially beneficial for those who may struggle with traditional pull-start mechanisms, allowing for a smoother experience right from the beginning of use. Additionally, the chainsaw comes with an integrated air filtration system that prolongs the life of the engine by ensuring cleaner airflow, which helps maintain optimal performance over time.

Another characteristic that sets the Poulan 178249 apart is its built-in chain brake safety feature. This critical component halts chain movement in the event of kickback, providing an added layer of protection for users. The adjustable chain tensioning system also allows for quick and easy adjustments on the go, ensuring that the chain remains properly tightened for efficient cutting.

Moreover, the Poulan 178249 has a translucent fuel tank that enables users to easily monitor fuel levels, reducing the risk of running out of fuel mid-task. This user-friendly design, along with the chainsaw’s durable construction, makes it suitable for various cutting applications in different environments.

In summary, the Poulan 178249 combines powerful performance, advanced technology, and user-oriented features, making it an excellent choice for anyone looking to invest in a reliable chainsaw. Whether you are maintaining your yard, clearing storm debris, or preparing firewood for the winter, this model is equipped to handle the demands of the job.
Top Page Image Contents