Poulan XT20H46YT Before Starting the Engine, Reverse Operation System ROS, To Operate on Hills

Page 11

OPERATION

REVERSE OPERATION SYSTEM (ROS)

Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the attachment clutch en- gaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystanders will enter the mowing area.

•Depress brake pedal all the way down.

•With engine running, turn ignition key counterclockwise to ROS "ON" position.

•Look down and behind before and while backing.

•Slowly depress reverse drive pedal to start move- ment.

•When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

02828

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

•To restart movement, slowly release parking brake and brake pedal.

•Slowly depress appropriate drive pedal to slowest set- ting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 3 and 11)

When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with attachment lift control.

•Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

Transmission Disengaged

FIG. 11

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Pull up and remove oil fill cap/dipstick; wipe oil off. Re- insert the dipstick into the tube and push down firmly into place. Remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Model XT20H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor Stopping HOW to USE Your TractorTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Transport See Figs Before Starting the EngineReverse Operation System ROS To Operate on HillsAutomatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge TransmissionMowing Tips Schedule MaintenanceMaintenance General RecommendationsTires BatteryTractor Brake OperationEngine Spark Plugs CleaningEngine OIL Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See -21 Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig To Replace Mower Drive Belt See FigTo Check Brake To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXLimited Warranty Service Notes Service Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Remarques Dentretien Remarques Dentretien Remarques Limitée Garantie UNE Pliez EST Ceci Degrés Suivant LESConnexions les et interrupteurs les câblage, le Vérifiez Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Moteur Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET RevisionAvant Roue LA DE PINCEMENT/CARROSSAGE Fig la Voir Batterie LA ReplacerFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour 27 .FIG Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Freins LES Vérifier Pour23 .FIG Tondeuse LA Niveau LE Ajuster Pour25 .FIG 24 .FIG18 .FIG 21 .FIG 19 .FIG20 .FIG 17 .FIG Courroie LA ET Tondeuse LA InstallerFig Voir Tondeuse LA Enlever PourMoteur DE D’HUILE Filtre EntretienFig la Voir ’ALLUMAGE BougieTransmission LA DE Refroidissement AIR À Filtre’AIR Tamis LE Nettoyer Sionmistrans LA DE Moteur FluideEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Lubrification DE Tableau12 .FIG UtilisationSion Transmis DE Réchauffement Transmission LA PurgerMoteur LE Démarrer Pour QuetimaautoMAR EN Fonctionnement DE Système 11 et 3 .Fig les VoirSystème DU Caractéristiques Tondeuse LA Utiliser PourJauge DE Roues LES Régler Pour 10 .FIGFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourVitess DE Régulateur LE Utiliser CommentUtilisation ’EMBRAYAGE LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Fig la Voir Siège LE Ajustez Montées NON PiécesToncar DU Tracteur LE Sortir Pour Fig la Voir Batterie LA VérifierSommaire ’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute En l’utilisation pour ConseilsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement AUX Imprimé

XT20H46YT specifications

The Poulan XT20H46YT is a robust and versatile riding lawn mower designed for homeowners seeking efficiency and performance in their lawn care routine. Built with power and durability in mind, this model showcases a variety of features that cater to different mowing needs and preferences.

At the heart of the XT20H46YT is its powerful 20 HP Briggs & Stratton engine, which delivers reliable performance across various terrains. The engine's design includes an easy starting system, ensuring that users can get to mowing without the frustration of traditional pull-starts. This engine pairs seamlessly with a hydrostatic transmission, allowing for smooth acceleration and effortless control of speed. This eliminates the need for shifting gears, making it user-friendly for both novice and experienced operators.

One of the standout features of the XT20H46YT is its 46-inch cutting deck. This mid-sized deck strikes an ideal balance between maneuverability and cutting efficiency, allowing users to cover larger areas while maintaining a compact size suitable for residential lawns. The mowing deck also includes a cutting height adjustment feature, which offers six preset positions, enabling homeowners to customize their lawn's appearance based on personal preference and grass type.

The Poulan XT20H46YT takes advantage of advanced technologies to enhance the user experience. Its reinforced frame construction adds durability, ensuring that the mower can withstand the rigors of regular use. Furthermore, the mower boasts larger rear tires that improve traction and stability, especially when navigating uneven surfaces or inclines.

Comfort is another priority for Poulan, and the XT20H46YT is equipped with a comfortable, high-back seat that provides support during extended mowing sessions. The ergonomically designed steering wheel is positioned for easy access, and the simple control layout allows for intuitive operation, minimizing distractions while focusing on the task at hand.

Maintenance is made easier with features such as an accessible deck wash port, which simplifies the cleaning process after mowing. Regular maintenance is crucial for optimal performance, and this added convenience encourages users to keep their equipment in top shape.

In summary, the Poulan XT20H46YT is an impressive riding lawn mower that combines power, comfort, and advanced features. With its dependable engine, user-friendly hydrostatic transmission, and versatile cutting deck, this model is a sound investment for anyone looking to maintain a pristine lawn with ease and efficiency.
Top Page Image Contents