Poulan PXT16542 Tools Required for Assembly, To Remove Tractor from Carton, Unpack Carton

Page 6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

5/16" wrench

Utility knife

(2)

7/16" wrenches

Tire pressure gauge

(2) 1/2" wrenches

Pliers

(1)

9/16" wrench

 

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton .

•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

TO INSTALL STEERING WHEEL (See Fig. 2)

ASSEMBLE EXTENSION SHAFT AND BOOT

•Slide extension shaft onto lower steering shaft.

•Place tabs of steering boot over tab slots in dash and push down to secure.

INSTALL STEERING WHEEL

•Position front wheels of the tractor so they are pointing straight forward.

•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.

•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.

•Assemble large flat washer, lock washer, hex bolt and tighten securely.

•Snap steering wheel insert into center of steering wheel.

•Remove protective materials from tractor hood and grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.

BEFORE REMOVING TRACTOR FROM SKID

TO CHECK BATTERY (See Fig. 1)

•Lift seat to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.

SEAT

LABEL

02602

Fig. 1

INSERT

BOLT

LOCK

WASHER

LARGE FLAT

WASHER

STEERING

WHEEL

STEERING

BOOT

ADAPTER

LOWER

EXTENSION

SHAFT

STEERING

SHAFT

 

Fig. 2

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents PXT16542 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Deck Levelness Install Seat See FigCheck Tire Pressure Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Before Starting the EngineTo Operate on Hills To TransportMowing Tips ADD GasolineTo Start Engine See Fig Maintenance Lubrication ChartPowdered Graphite Type Lubricant Sparingly Blade Care BatteryTractor Blade Removal See FigCleaning EngineTo Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig Belt RemovalTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Carburetor Interlocks and RelaysFuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionWhen turning To run when operBattery will not ExcessiveOnly Ride UP and Down Hill Not Across Hill Degrees MAX Fold Alon THI Dotted Line REE LopeCanada contact Outdoor Products Customer Service DeptHOP Stevens Creek Road Terry Fox Way Augusta, GA 30907 USADept Service Customer Products Outdoor Canada Au AutoriséGarantie cette de exclus sont normal l’entretien et Degrés MAX Dépannage DE Guide Correction Cause ProblèmePuissance de Entreposage Réglages ET Révision Carburateur LE Régler PourFig la Voir Calandre LA ET Capot LE Enlever Pour DE Levier DU Neutre AU Réglage Fig la VoirVitesses DE Boîte LA DE Mentgechan Direction DE Volant LA DE L’ALIGNEMENT Régler PourFreins LES Vérifier Pour Tondeuse DE Lame DE D’ENTRAÎNEMENTCourroie Acer Rempl Pour 14 .FIG DE Boîtier LE Niveau DE Mettre PourSedeuton 16 et 15 .Fig les Voir Lautre À Côté DUN RéglageEntretien MoteurLames DES Entretien Fig la Voir Lame LA EnleverTrapézoïdales Courroies PneusUtilisation Chaque Avant Lubrification DE TableauMoteur de d’huile niveau le Vérifiez ’ESSENCE Réservoir LE Remplir UtilisationTonte DE Conseils Dhiver Spéciale ET Propre FRAÎCHE, L’ESSENCE DETracteur LE Transporter Pour Accessoires AutresMoteur DU D’HUILE Niveau LE Vérifier Arrière Marche EN FonctionnementGAZ DES Commande LA Utiliser Pour T O S I L I T U02829 Moteur Place EN Correctement MontageFrein DE Système LE Vérifier Sont Courroies LES Toutes SI VérifierTionrecdi DE Volant LE Fixer DE Tracteur LE Retirer AvantFig la Voir Batterie LA Vérifier Carton LE DeballerMontar SIN Piezas SiègeSommaire Remorquage EnfantsEntretien Général EntretienTracteurs des sécurité toute en l’utilisation pour Conseils AvertissementPentes LES Dans Fonctionnement Général FonctionnementPelouse DE Tracteur PXT16542

PXT16542 specifications

The Poulan PXT16542 is a robust and efficient lawn mower designed for homeowners seeking a reliable and powerful cutting tool for their gardens. Boasting a 42-inch cutting deck, this riding mower is perfectly suited for medium to large lawns, enabling efficient coverage and reduced mowing time.

One of the standout features of the PXT16542 is its powerful 16.5 HP Briggs & Stratton engine. This engine delivers optimized performance with substantial torque, ensuring seamless maneuverability and cutting power on various terrains. The integrated automatic transmission further enhances the mowing experience by allowing smooth speed adjustments, making it easy to navigate around obstacles and uneven surfaces.

A crucial technology in the PXT16542 is its cutting system, featuring a dual-blade design that provides a clean and precise cut every time. With multiple height adjustment settings, users can customize the cutting height to suit their lawn's needs, whether they prefer a close trim or a higher grass finish. This flexibility is essential for maintaining a healthy lawn and promoting robust growth.

The Poulan PXT16542 is also designed for user comfort and convenience. Its ergonomic seat ensures a comfortable riding experience, even during extended mowing sessions. Easy-to-reach controls make operation intuitive, while the easy-access fuel tank simplifies refueling. The inclusion of a tight turning radius allows for exceptional maneuverability, making it easy to navigate tight spots or flowerbeds without damaging the landscape.

Durability and maintenance are prioritized in this mower’s design. The rugged construction and high-quality materials used in the PXT16542 contribute to its longevity and reliability. Additionally, the mower comes with maintenance points conveniently located for easy access, allowing for quick checks and upkeep, which ultimately prolongs the life of the machine.

In summary, the Poulan PXT16542 is an ideal choice for homeowners needing a reliable, user-friendly riding mower. With its powerful engine, versatile cutting capabilities, user-centric design, and durable construction, this mower stands out as a dependable partner for lawn care, ensuring that your garden remains in pristine condition throughout the mowing season.
Top Page Image Contents