Poulan PPB200 LE Shoulder Strap Adjustment, Know Your Blower, Throttle Lever, Primer Button

Page 5

SHOULDER STRAP ADJUSTMENT

1.Hold the unit as shown with the muffler side facing away from your body and clothes.

2.Pass the shoulder strap over your head and onto your right shoulder.

3.Extend your left arm toward the rear of the vacuum bag.

4.Adjust shoulder strap until the vacuum bag/shoulder strap seam lies between your thumb and index finger.

5.Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.

KNOW YOUR BLOWER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

Upper Vacuum Tube

Lower Vacuum Tube

Vacuum Bag

Throttle

Lever

Elbow Tube

Spark Plug

 

Primer Button

Choke Lever

Fuel Mix

Fill Cap

Starter

Rope

Blower

Tube

Rear

Handle

THROTTLE LEVER

The THROTTLE LEVER is used to select the desired engine speed and to stop the engine.

Move the throttle lever to the

position for

full speed operation. Move the throttle lever

to the position for idle speed. To stop the engine, move the throttle lever to the STOP position.

PRIMER BUTTON

The PRIMER BUTTON removes air from the carburetor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate primer button by pressing it and allowing it to return to its origi- nal position.

CHOKE LEVER

The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After engine attempts to start, move the choke lever to the HALF CHOKE position. Once engine starts, move choke lever to the RUN position.

-- 5 --

Image 5
Contents Manual de Instrucciones Manuel d’Instructions Plan Ahead Know Your UnitHandle Fuel with CAUTION, IT is Highly Flammable Operate Your Unit SafelyMaintain Your Unit Properly Blower Tube AssemblyVacuum BAG Assembly HOW to Convert Unit from Vacuum USE to Blower USE Vacuum Tube AssemblyKnow Your Blower Shoulder Strap AdjustmentThrottle Lever Primer ButtonOperating Tips Operating PositionBefore Starting Engine Fueling Engine To Stop the EngineStarting a Warm Engine Starting a Cold EngineStarting a Flooded Engine General RecommendationsClean AIR Filter Inspect and Clean Unit and DecalsCheck Muffler Mounting Screws Replace Spark PlugSeasonal Storage Carburetor AdjustmentsFuel System EngineAdjustment Crankshaft seals worn Troubleshooting Table Cause RemedyAdjustment Carbon build upTions The U.S. Environmental Protection Electrolux Home PRODUCTS, INC