Poulan PRGT22H50D To Remove Wheel for Repairs, To Start Engine with a Weak Battery See Fig

Page 24

SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL FOR REPAIRS

FRONT WHEEL (See Fig. 30)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal.

•Repair tire and reassemble.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

REAR WHEEL -

•Block rear axle securely.

•Remove five (5) hub bolts to allow wheel removal.

•Repair tire and reassemble. Replace and tighten hub bolts securely.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

“POSITIVE”

(+)

“NEGATIVE” (-)

 

 

L.H. PANEL

 

 

BOLT

FIG. 31

WASHERS

RETAINING

RING

AXLE

COVER

FIG. 30

TO START ENGINE WITH A WEAK BATTERY (See Fig. 31)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See “BATTERY” in the Customer Responsibili- ties section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

REPLACING BATTERY (See Fig. 32)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal guard.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal guard.

•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

•Close terminal access doors.

•Close hood.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PRGT22H50D ModelIV. Service Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationSafety Rules Table of Contents Unassembled Parts Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels and Brackets to Mower Deck See FigInstall Mower and Drive Belt See Figs To Attach Nose Roller See FigCheck Tire Pressure Check Mower LevelnessCheck for Proper Position of ALL Belts Operation Height Adjustment Knob Used to adjust the mower height Know Your TractorHOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigsTo Operate on Hills To Transport See FigsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionLubrication Chart ¡ Customer ResponsibilitiesGeneral Recommendations Before Each USETractor Engine Cleaning MufflerSpark Plugs Engine OIL FilterService and Adjustments To Install MowerTo Level Mower Housing To Remove Mower See FigTo Replace Mower Drive Belt To Replace Mower Blade Drive Belt See FigTo Adjust Attachment Clutch See Fig To Replace Motion Drive Belt See FigTransaxle Motion Control Lever Neutral Adjustment See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel Alignment Front Wheel TOE-IN AdjustmentTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Remove Wheel for Repairs To Adjust Attachment Lift Spring See Fig To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigTo Adjust Carburetor Other Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionOFF Service Notes Schematic Tractor - Model Number PRGT22H50DElectrical KEY Part Description Chassis and Enclosures Repair Parts Ground Drive 149153 4497H Steering Assembly Adapter, Wheel Steering Engine Spark Arrester KITScrew Hex Hd Cap 5/16-18 x 3/4 Seat Assembly Lift Assembly Mower Deck Washer, Hard Blade Mower Vented Decals Wheels & TiresService Notes Service Notes Service Notes Limited Warranty CUT This OUT Dotted Lines SlopeParts and Service

PRGT22H50D specifications

The Poulan PRGT22H50D is a standout in the realm of outdoor power equipment, specifically designed for homeowners seeking a reliable and efficient lawn tractor. Renowned for its robust features and user-friendly design, the PRGT22H50D delivers exceptional performance for lawn care enthusiasts.

One of the key features of this lawn tractor is its powerful 22-horsepower engine, providing ample horsepower to tackle even the toughest grass. This engine is engineered for durability and efficiency, allowing users to cover more ground at an impressive speed. The tractor is equipped with a 50-inch cutting deck, offering a wide cutting path that reduces the time spent mowing. The cutting deck design allows for superior grass dispersion, leaving a well-manicured lawn in its wake.

The PRGT22H50D incorporates a hydrostatic transmission, which provides a smooth and effortless driving experience. This type of transmission allows for seamless speed changes without the need for gear shifting, making it user-friendly for operators of all experience levels. The intuitive controls are strategically placed, allowing for easy maneuverability around obstacles, ensuring that every inch of grass is trimmed with precision.

Comfort is at the forefront of the design, featuring an adjustable high-back seat that promotes better posture and reduces fatigue during longer mowing sessions. Additionally, the lawn tractor includes a steering wheel that is ergonomically designed for ease of use, enhancing the overall comfort of the operator.

Another notable technology in the Poulan PRGT22H50D is its cutting height adjustment feature, which allows users to customize the height of their cut with ease. This versatility ensures that homeowners can achieve the ideal grass length for their specific lawn needs.

Safety features are also integrated into the design, with a built-in safety switch that helps prevent accidental starts when the operator is not in the seat. This attention to safety reflects Poulan’s commitment to ensuring a secure mowing experience.

Overall, the Poulan PRGT22H50D is an impressive lawn tractor that marries power, comfort, and cutting-edge technology, making it an ideal choice for any homeowner looking to maintain their lawn efficiently and effectively. Whether for small yards or larger properties, this tractor promises to deliver a reliable performance that meets the demands of modern lawn care.
Top Page Image Contents