Poulan PR25PH48STA Replacing Battery See Fig, To Replace Headlight Bulb, Interlocks and Relays

Page 24

SERVICE AND ADJUSTMENTS

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TERMINAL ACCESS DOOR

TERMINAL GUARD

KEPS NUT

HEX

BOLT

POSITIVE (RED)

CABLE

NEGATIVE (BLACK)

CABLE

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

“POSITIVE”

“NEGATIVE”

(+)

(-)

L.H. PANEL

 

BOLT

 

FIG. 29

REPLACING BATTERY (See Fig. 30)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,rings,etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift hood to raised position.

•Remove terminal guard.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal guard.

•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

•Close terminal access doors.

•Close hood.

FIG. 30

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 31)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedures.

HOOD

HEADLIGHT

WIRE

CONNECTOR

FIG. 31

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PR25PH48STA Safety Rules Safe Operation Practices for Ride-On MowersSafety Rules Table of Contents Unassembled Parts Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck See FigInstall Mower and Drive Belt See Figs To Attach Nose Roller See FigCheck Tire Pressure Check Mower LevelnessCheck for Proper Position of ALL Belts Check Brake SystemBattery Reverse Forward Fast OperationKnow Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsLubrication Chart Service DatesCustomer Responsibilities General RecommendationsTractor Engine Cleaning MufflerSpark Plugs Engine OIL FilterService and Adjustments To Install MowerTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Adjust Brake See Fig To Replace Mower Drive BeltTo Replace Mower Blade Drive Belt See Fig Transmission REMOVAL/REPLACEMENT To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER Replacing Battery See Fig To Remove Hood and Grill Assembly See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigTo Adjust Carburetor Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionOFF Schematic Tractor Model Number PR25PH48STANON-REMOVABLE Removable Connections Connections Electrical KEY Part Description Chassis and Enclosures Bracket Fender Repair Parts DriveTransaxle Order parts from Steering Assembly 175118 Bolt Shoulder 7/16-20 Unc 175553 Clip Engine Seat Assembly Decals Wheels & TiresMower Lift Mower Deck Washer, Spacer Mower Vented Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Service Notes Service Notes Parts and Service

PR25PH48STA specifications

The Poulan PR25PH48STA is a powerful and versatile lawn mower designed for homeowners who seek a reliable solution for lawn care. This model is particularly known for its robust performance, ease of use, and advanced features that make mowing lawns a seamless experience.

One of the main features of the Poulan PR25PH48STA is its 25cc two-cycle engine, which provides strong power while ensuring efficient fuel consumption. This engine is designed for durability and performance, allowing users to tackle various types of grass and terrain without struggle. The lightweight design of the mower makes it easy to maneuver, providing users with greater control while mowing.

The PR25PH48STA also boasts a 48-inch cutting deck that enables a wider cutting path, allowing for quicker mowing sessions. This feature is especially beneficial for larger lawns, as it reduces the number of passes needed to achieve a well-manicured look. Additionally, the deck is equipped with multiple height adjustments, allowing users to select the perfect cutting height for their lawn's unique needs.

One innovative technology featured in the Poulan PR25PH48STA is its automatic choke system. This technology simplifies the starting process, making it easier for users to start the mower with minimal effort. The automatic choke adjusts as needed, ensuring optimal engine performance under diverse conditions.

Another notable characteristic of the PR25PH48STA is its ergonomic handle design. The handle is adjustable, allowing users to comfortably operate the mower without straining their backs or arms. This thoughtful design enhances user comfort, particularly during extended mowing sessions.

For added convenience, the Poulan PR25PH48STA features a reliable rear-wheel drive system that provides improved traction and stability on different terrains. This feature is especially useful for navigating hilly or uneven lawns, ensuring users can maintain control throughout the mowing process.

In summary, the Poulan PR25PH48STA is an excellent choice for homeowners who prioritize performance and convenience in their lawn care equipment. With its powerful engine, wide cutting deck, automatic choke system, and ergonomic design, this mower stands out as a reliable option for maintaining a beautiful lawn with ease. Whether dealing with large open spaces or intricate landscaping, the PR25PH48STA is engineered to make lawn maintenance effective and enjoyable.
Top Page Image Contents