Poulan PR25PH48STA owner manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 21

SERVICE AND ADJUSTMENTS

NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower side-to-side to give space between plate and mower brackets.

IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.

•Engage belt tension rod by pushing rod into locking bracket.

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

•Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

•If equipped, turn height adjustment knob clockwise to remove slack from mower suspension.

•Raise deck to highest position.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 20 and 21)

•Raise mower to its highest position.

•Measure height from bottom edge of mower to ground level at front corners of mower. Distance “A” on both sides of mower should be the same.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Recheck measurements after adjusting.

BOTTOM EDGE

 

BOTTOM EDGE

OF MOWER TO

 

OF MOWER TO

GROUND

 

GROUND

A

GROUND LINE

A

FIG. 20

SUSPENSION ARM

LIFT LINK ADJUSTMENT NUT

FIG. 21

FRONT-TO-BACK ADJUSTMENT (See Figs. 22 and 23)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-SIDE.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is approximately 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION:Bladesaresharp.Protectyour hands with gloves and/or wrap blade with heavy cloth.

Check adjustment on right side of tractor. Position any blade so the tip is pointing straight forward. Measure distance "B" at front and rear tip of the blade.

•Before making any necessary adjustments, check that both front links are equal in length.

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of blade, loosen nut “C” on both front links an equal number of turns.

NOTE: Each full turn of nut “C” will change distance. “B” by approximately 3/16".

•When distance “B” is 1/8" to 1/2" lower at front than rear, tighten nut “D” against trunnion on both front links.

MANDREL

“B”“B”

FIG. 22

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

 

TRUNNION

NUT “D”

 

FRONT

NUT “C”

PLATE

 

ASSEMBLY

 

FIG. 23

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents PR25PH48STA Safe Operation Practices for Ride-On Mowers Safety RulesSafety Rules Table of Contents Unassembled Parts Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonAssemble Gauge Wheels to Mower Deck See Fig Install Seat See FigTo Attach Nose Roller See Fig Install Mower and Drive Belt See FigsCheck Mower Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Battery Reverse Forward FastKnow Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionService Dates Lubrication ChartCustomer Responsibilities General RecommendationsTractor Engine Muffler CleaningSpark Plugs Engine OIL FilterService and Adjustments To Install MowerTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Adjust Brake See Fig To Replace Mower Drive BeltTo Replace Mower Blade Drive Belt See Fig Transmission REMOVAL/REPLACEMENT To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER To Remove Hood and Grill Assembly See Fig Replacing Battery See FigTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigTo Adjust Carburetor Other StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsOFF Schematic Tractor Model Number PR25PH48STANON-REMOVABLE Removable Connections Connections Electrical KEY Part Description Chassis and Enclosures Bracket Fender Drive Repair PartsTransaxle Order parts from Steering Assembly 175118 Bolt Shoulder 7/16-20 Unc 175553 Clip Engine Seat Assembly Wheels & Tires DecalsMower Lift Mower Deck Washer, Spacer Mower Vented Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Service Notes Service Notes Parts and Service

PR25PH48STA specifications

The Poulan PR25PH48STA is a powerful and versatile lawn mower designed for homeowners who seek a reliable solution for lawn care. This model is particularly known for its robust performance, ease of use, and advanced features that make mowing lawns a seamless experience.

One of the main features of the Poulan PR25PH48STA is its 25cc two-cycle engine, which provides strong power while ensuring efficient fuel consumption. This engine is designed for durability and performance, allowing users to tackle various types of grass and terrain without struggle. The lightweight design of the mower makes it easy to maneuver, providing users with greater control while mowing.

The PR25PH48STA also boasts a 48-inch cutting deck that enables a wider cutting path, allowing for quicker mowing sessions. This feature is especially beneficial for larger lawns, as it reduces the number of passes needed to achieve a well-manicured look. Additionally, the deck is equipped with multiple height adjustments, allowing users to select the perfect cutting height for their lawn's unique needs.

One innovative technology featured in the Poulan PR25PH48STA is its automatic choke system. This technology simplifies the starting process, making it easier for users to start the mower with minimal effort. The automatic choke adjusts as needed, ensuring optimal engine performance under diverse conditions.

Another notable characteristic of the PR25PH48STA is its ergonomic handle design. The handle is adjustable, allowing users to comfortably operate the mower without straining their backs or arms. This thoughtful design enhances user comfort, particularly during extended mowing sessions.

For added convenience, the Poulan PR25PH48STA features a reliable rear-wheel drive system that provides improved traction and stability on different terrains. This feature is especially useful for navigating hilly or uneven lawns, ensuring users can maintain control throughout the mowing process.

In summary, the Poulan PR25PH48STA is an excellent choice for homeowners who prioritize performance and convenience in their lawn care equipment. With its powerful engine, wide cutting deck, automatic choke system, and ergonomic design, this mower stands out as a reliable option for maintaining a beautiful lawn with ease. Whether dealing with large open spaces or intricate landscaping, the PR25PH48STA is engineered to make lawn maintenance effective and enjoyable.
Top Page Image Contents