Poulan PP4218AVHD instruction manual Other, Load Adjustment Engine

Page 17

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distrib- ute oil.

SReplace spark plug with new one of rec- ommended type and heat range.

SClean air filter.

SCheck entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

S Replace your gasoline can if it starts to rust.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

Engine will not

1. Ignition switch off.

1.

Move ignition switch to ON.

start or will run

2. Engine flooded.

2.

See “Difficult Starting” in

only a few

 

 

 

Operation Section.

seconds after

3. Fuel tank empty.

3.

Fill tank with correct fuel mixture.

starting.

4. Spark plug not firing.

4.

Install new spark plug.

 

5. Fuel not reaching

5.

Check for dirty fuel filter; replace.

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

repair or replace.

 

 

 

 

 

Engine will

1.

Idle speed requires

1. See “Carburetor Adjustment” in the

not idle

 

adjustment.

 

Service and Adjustments Section.

properly.

2.

Carburetor requires

2. Contact an authorized service dealer.

 

 

adjustment.

 

 

 

Engine will not

1.

Air filter dirty.

1. Clean or replace air filter.

accelerate,

2.

Spark plug fouled.

2. Clean or replace plug and regap.

lacks power,

3.

Chain brake engaged.

3. Disengage chain brake.

or dies under

4.

Carburetor requires

4. Contact an authorized service dealer.

a load.

 

adjustment.

 

 

 

Engine

1.

Too much oil mixed with

1.

Empty fuel tank and refill with

 

smokes

 

gasoline.

 

correct fuel mixture.

excessively.

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

17

Image 17
Contents 12/8/05 Electrolux Home Products, IncPlan Ahead Hearing Safety Hat Protection Eye Snug FittingMaintain Your SAW in Good Working Order Operate Your SAW SafelyHandle Fuel with Caution KickbackMaintain Control Kickback Safety FeaturesReduce the Chance of Kickback WE do not REP Chain Brake and CKA AngleResent and YOU should not AS Sume That the Chain Brake willChain adjustment tool Bar Tool AssemblyAttaching the BAR & Chain If not ShippingAdjusting Screw Adjusting the tensionChain Tension Checking the tensionOperation BAR and Chain Lubrication Before Starting Engine Fueling EngineImportant Points to Remember Cation Always stop the engine before removing the oil capStarting a Warm Engine Choke Lever Move ON/STOP switch to the on posi- tionDifficult Starting or starting a flooded engine Braking function control Caution The chain brake must beTree Felling Techniques Operating TipsFelling Large Trees Notch CUT and Felling the TreeCutting a Fallen Tree Bucking Using a LOG or Support StandImportant Points Types of Cutting Used for BuckingLimbing Limbing and Pruning Important PointsPruning ING Without a SupportService Clean AIR Filter Inspect and Clean Unit and DecalsCleaning the Spark ARREST- ING Screen Check Fuel Mixture LevelStorage Other Load Adjustment EngineEngine Electrolux Home PRODUCTS, INC Tions The U.S. Environmental ProtectionConsequential Damages Electro