Infinity TSS-SAT4000 Wiring the Speaker, Care of Your Speaker System, Step Six, Surround Modes

Step Six

The wall-bracket design allows for rotation of the speakers at angles up to 30 degrees of center. Position the speakers so they face toward the primary listening position, before fully tightening.

WIRING THE SPEAKER

After placing the speaker, you are ready to connect it to your system. First, turn off all audio-system power. Use high-quality speaker wire to make the connections. Consult the owner’s manuals, included with your amplifier or receiver, for connection and operation procedures.

Surround Modes

When using the TSS-SAT4000 in a Dolby* Digital or DTS® home theater system, make sure the receiver’s/processor’s speaker modes are set to “Small.”

Wiring and Polarity

The TSS-SAT4000 speaker has gold-plated terminals that can accept bare wire. To ensure proper polarity, connect each

+terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown in Figure 3. Connect the – (black) terminals in a similar way.

See the owner’s manuals that were included with your amplifier or receiver to confirm connection procedures.

Important!

Do not reverse polarities (i.e., + to – or – to +) when making connections. Doing so will degrade the imaging and bass response of the home theater system.

After correctly placing and wiring the TSS-SAT4000 and the rest of your speaker system, adjust the levels for all of the channels as recommended by the manufacturer of your receiver/processor.

2 1

– +

Figure 3. This example shows how to connect bare wires to the terminals. Banana plugs may also be inserted directly into the rear of the connector.

1Loosen the terminals.

2Insert bare ends; tighten terminals.

CARE OF YOUR SPEAKER SYSTEM

When needed, use a soft cloth to remove any fingerprints or to wipe off dust. Do not use any cleaning products or polished. Clean the grille by gentle vacuuming.

TSS-SAT4000 9