LUBRICATION
Bar Oil Fill Cap
S Check bar and chain oil before use and every 15 minutes while operating
the saw. See GUIDE BAR AND CHAIN OIL under the OPERATION section.
INSPECT AND CLEAN UNIT AND LABELS
SAfter each use, inspect complete unit for loose or damaged parts. Clean the unit and labels using a damp cloth with
a mild detergent.
S Wipe off the unit and labels with a clean dry cloth.
SERVICE AND ADJUSTMENTS
CHAIN SHARPENING
Chain sharpening requires special tools. You can purchase sharpening tools at an authorized service dealer or go to a pro- fessional chain sharpener.
WARNING: Avoid accidental start- ing. Always unplug saw from power source before installing a bar and/or chain.
CHAIN REPLACEMENT
WARNING: Wear protective gloves when handling chain. The chain is sharp and can cut you even when it is not moving.
It is normal for a new chain to stretch dur- ing the first 15 minutes of operation. You should recheck your chain tension fre- quently and adjust the chain tension as required. See CHECK CHAIN TENSION section.
Replace the old chain when it becomes worn or damaged. Use only the Low Kickback replacement chain specified in the list of available replacement parts. The chain must comply with kickback re- quirements of ANSI B175.1 when tested with this saw. See your authorized ser- vice dealer to replace and sharpen indi- vidual cutters on your chain.
TO REPLACE CHAIN:
1.Disconnect the chain saw from the power source.
2.Remove bar clamp nuts.
3.Remove bar clamp and old chain.
Bar Clamp
Nuts
Bar | Adjusting Screw |
Clamp |
|
13
4.Turn the adjusting screw counter- clockwise to move the adjusting pin almost as far as it will go to the rear. Do not remove the adjusting screw from the bar clamp.
5.Carefully remove the new chain from the package. Hold chain with cutters facing as shown.
Tip of
Bar
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Cutters | Depth Gauge |
Drive Links
6.Place chain around the sprocket and fit the drive links into the guide bar groove and then into the teeth of the sprocket in the tip of the guide bar.
7.Hold the guide bar against the saw frame and install the bar clamp. Be sure adjusting pin is in the adjusting pin hole in the bar.