Poulan 2004-06 Starting, Fueling Engine, BAR and Chain Lubrication, Important Points to Remember

Page 9

FUELING & LUBRICATION

STARTING

WARNING: Remove fuel cap slow- ly when refueling.

FUELING ENGINE

This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand synthetic oil is recommended. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3.2 ounces (95 ml) of oil with 1 gallon (4 liters) of unleaded gasoline. Included with this saw is a 3.2 ounce container of oil. Pour the entire contents of this container into 1 gallon of gasoline to achieve the proper fuel mixture. DO NOT USE automotive oil or boat oil. These oils will cause engine damage. When mixing fuel, follow instructions printed on container. Once oil is added to gasoline, shake container momentarily to assure that the fuel is thoroughly mixed. Always read and follow the safety rules relating to fuel before fueling your unit.

BAR AND CHAIN LUBRICATION

The bar and chain require continuous lubri- cation. Lubrication is provided by the auto- matic oiler system when the oil tank is kept filled. Lack of oil will quickly ruin the bar and chain. Too little oil will cause overheating shown by smoke coming from the chain and/ or discoloration of the bar.

In freezing weather oil will thicken, making it necessary to thin bar and chain oil with a small amount (5 to 10%) of #1 Diesel Fuel or kerosene. Bar and chain oil must be free flowing for the oil system to pump enough oil for adequate lubrication.

Genuine Poulan or Poulan PROR bar and chain oil is recommended to protect your unit against excessive wear from heat and friction. Poulan or Poulan PROR oil resists high temperature thinning. If Poulan or Poulan PROR bar and chain oil is not available, use a good grade SAE 30 oil.

SNever use waste oil for bar and chain lubri- cation.

SAlways stop the engine before removing the oil cap.

IMPORTANT

Experience indicates that alcohol--blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See STORAGE section for addi- tional information.

WARNING: The chain must not move when the engine runs at idle speed. If the chain moves at idle speed refer to CAR- BURETOR ADJUSTMENT within this manual. Avoid contact with the muffler. A hot muffler can cause serious burns.

To stop the engine move the ON/STOP switch to the STOP position.

To start the engine hold the saw firmly on the ground as illustrated. Make sure the chain is free to turn without contacting any object.

Use only 15”--- 18” of rope per pull. Hold saw firmly while pulling starter rope.

Starter rope handle

Left hand on front handle

Right foot through rear handle

IMPORTANT POINTS TO REMEMBER

When pulling the starter rope, do not use the full extent of the rope as this can cause the rope to break. Do not let starter rope snap back. Hold the handle and let the rope rewind slowly.

For cold weather starting, start the unit at FULL CHOKE; allow the engine to warm up before squeezing the throttle trigger.

NOTE: Do not cut material with the choke/ fast idle lever at the FULL CHOKE position.

STARTING A COLD ENGINE (or warm engine after running out of fuel)

NOTE: In the following steps, when the choke/fast idle lever is pulled out to the full extent, the correct throttle setting for starting is set automatically.

ON/STOP SWITCH

(SIDE VIEW)

ON

STOP

1.Move ON/STOP switch to the ON posi- tion.

2.Pull out choke/fast idle to the full extent (to the FULL CHOKE position).

3.Slowly press primer bulb 6 times.

4.Pull the starter rope sharply 5 times with your right hand. Then, proceed to the next step.

NOTE: If the engine sounds as if it is trying to start before the 5th pull, stop pulling and immediately proceed to the next step.

5.Push the choke/fast idle lever in to the HALF CHOKE position.

9

Image 9
Contents English Español Français Manual de Instrucciones Manuel d’InstructionsIdentification of Symbols Safety RulesPlan Ahead Maintain Your SAW in Good Working Order Operate Your SAW SafelyHandle Fuel with Caution KickbackReduce the Chance of Kickback Kickback Safety FeaturesMaintain Control Avoid Obstructions Clear The Working AreaComputed kickback angle CKA Table Chain Brake and CKA AngleLength 530044834 16″ 530051211Attaching the BAR & Chain If not AssemblyChain Brake Nuts Mount the BarChain Tension Including units with chain already installed Adjusting the tensionGuide bar Adjusting Screw Checking the tensionKnow Your SAW ON/STOP SwitchThrottle Trigger Throttle LockoutFueling Engine StartingBAR and Chain Lubrication Important Points to RememberCutting Methods Starting a Warm EngineImportant Points Felling Large Trees Tree Felling TechniquesNotch CUT and Felling the Tree Direction of FallCutting a Fallen Tree Bucking Using a LOG or Support StandTypes of Cutting Used for Bucking Bucking Without a SupportLimbing and Pruning Important Points ServiceLimbing PruningCarburetor Adjustment Cleaning the air filterBAR Maintenance Inspect Muffler and Spark Arresting ScreenNeed ASSISTANCE? Limited Warranty Load Adjustment EngineEmpty fuel tank and refill with Electrolux Home PRODUCTS, INC Ligations The U. S. EnvironmentalIntermediate 125 hours Extended 300 hours

2004-06, 530164817 specifications

The Poulan 2004-06, model 530164817, is a formidable machine in the world of outdoor power equipment, particularly known for its reliability and efficiency. Designed primarily for homeowners and light landscaping professionals, this model combines user-friendly features with robust performance.

One of the standout characteristics of the Poulan 530164817 is its powerful engine. This chainsaw is equipped with a reliable two-cycle engine, delivering ample horsepower for various cutting tasks. The engine's design emphasizes reduced emissions, which aligns with current environmental standards, making it both efficient and eco-friendly. Its ability to handle a wide range of materials, from small branches to larger logs, makes it a versatile tool for any outdoor project.

The chainsaw features an automatic oiler system, ensuring that the chain remains well-lubricated during operation. This prolongs the life of both the chain and the guide bar, reducing maintenance requirements and downtime. The easy-access air filter enhances engine efficiency by allowing debris to be removed quickly, ensuring that the tool operates at peak performance.

In terms of ease of use, the Poulan 530164817 is designed with the user in mind. It features an ergonomic handle that provides a comfortable grip, reducing fatigue during extended use. Additionally, the chainsaw is equipped with a primer bulb, allowing for easy starting, even in cold weather conditions. The tensioning system for the chain is also user-friendly, allowing for quick adjustments without the need for additional tools.

Safety is a critical aspect of any power tool, and the Poulan 530164817 incorporates several features to protect the user. It includes a chain brake, which can be activated in case of kickback, providing an essential layer of safety. The integrated safety throttle prevents accidental starts, further enhancing the user's protection while operating the chainsaw.

Overall, the Poulan 2004-06, model 530164817, is a well-rounded chainsaw that marries power with practicality. Its robust engine, automatic oiler, and user-centric design make it an excellent choice for anyone who needs a reliable cutting tool for both light-duty and medium-duty tasks. Whether tackling yard maintenance, firewood preparation, or other woodworking projects, this chainsaw delivers dependable performance and longevity, making it a smart investment for any home or garden enthusiast.