EDGER SAFETY
WARNING: Always use handlebar when operating edger attachment. Attach handlebar above arrow on safety label on the upper shaft (motor end of unit). If your edger attachment does not include a handlebar, a handlebar accessory kit (#530071864) is available from your authorized service dealer. Instructions for assembling handlebar to your unit are included in this kit.
SBlade rotates momentarily after the trigger is released. The blade can seriously cut
you or others.
SAllow blade to stop before removing it from the cut.
Handlebar
DANGER: RISK OF CUT. KEEP HANDS AND FEET AWAY FROM BLADE AND CUTTING AREA. Do not attempt to clear away cut material when the blade is in motion. Make sure switch is in the off position and the power source is disconnected when removing jammed material from the cutting blade. Do not grab or hold unit by the cutting blade.Inspect the area to be edged before each use. Re- move objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft.
WARNING: Inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft.
SHold the unit firmly with both hands.
SKeep firm footing and balance. Do not over- reach or stand on unstable surfaces.
SThrow away blades that are bent, warped, cracked, broken or damaged in any other way. Replace parts that are cracked, chipped, or damaged before using the unit.
SKeep all parts of your body away from the
blade.
S Keep blade guard in place and in good working order.
SAlways keep the wheel in contact with the
ground.
S Always push the unit slowly over the ground. Stay alert for uneven sidewalks, holes in the terrain, large roots, etc.
STo reduce the risk of fire, do not allow exces- sive grass, leaves, or grease to accumulate
on the attachment.
S Objects struck by the cutting member can cause serious injuries to persons. The lawn should always be carefully examined and cleared of all objects prior to edging.
SAVE THESE INSTRUCTIONS
WARNING: Use of any other attach- ments not recommended in this manual may in- crease the risk of injury to persons, fire, or elec- trical shock. Use of attachments not covered under the list of recommended attachments in this manual have not been evaluated for use with this powerhead by Underwriters Laborato- ries (see RECOMMENDED ATTACHMENTS).
WARNING: This unit is not designed for use with a brushcutter attachment.
VACUUM SAFETY
WARNING: Inspect area before starting unit. Remove all debris and hard ob- jects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.
S Never place objects inside the vacuum tube(s). Always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or to ricochet which can
hurt people or animals, break glass, or cause other damage.
S Never run unit without the proper equip- ment attached. When using your unit as a vacuum, always install vacuum tube(s).
SCheck air intake opening or vacuum tube(s) frequently, always with engine stopped and unit disconnected from power source. Keep vents and tubes free of debris which can ac- cumulate and restrict proper air flow.
PRUNER SAFETY (RECIPROCATING BLADE)
WARNING: The reciprocating blade can cause severe injury. Inspect the unit be- fore use. Do not operate unit with a bent, cracked or dull blade. Keep away from the blade.
WARNING: The reciprocating blade is sharp. Do not touch. To prevent serious injury, always stop engine and ensure blade has stopped moving, disconnect unit from power source, and wear gloves when changing or handling the blade.
8