1 | MOWER DECK BAFFLE (See Fig. 1) |
Use Hardware - - GROUP "A" |
1.Raise your tractor mower deck to its highest position.
2.Install the hex bolts, locknuts and acorn nuts through mower deck housing as shown.
3. Tighten all hardware securely. | ACORN NUT |
DISCHARGE
GUARD
ACORN NUT
LOCKNUT
LOCKNUT
HEX BOLT
| FIG. 1 | HEX BOLT |
|
| |
2 | REAR MOUNTING BRACKET |
|
(See Figs. 2A & 2B) |
|
NOTE: If your tractor already has four (4) shoulder bolts installed on the rear drawbar, simply hang the mounting bracket, lanced tabs towards bottom, on the bolts. Discard hardware group "B" and disregard the remaining Step 2 instructions.
| SHOULDER |
02 | BOLTS |
462 |
|
LANCED TABS
TOWARD BOTTOM
FIG. 2A
If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below.
Use Hardware - - GROUP "B"
1.Using the four formed holes in the drawbar, install the four shoulder bolts as shown and tighten securely.
2.Hang the mounting bracket, lanced tabs towards bottom, on the bolts.
SELF
TAPPING
SHOULDER
BOLTS
0 246 1
LANCED TABS
TOWARD BOTTOM
FIG. 2B
3 COVER SEAL (See Fig. 3) No hardware required
1.Align mark on seal with mark at cover opening.
2.Work seal into opening so cover sits between flanges of seal.
ALIGNMENT
MARKS
| 02085 |
| COVER SEAL |
| FIG. 3 |
4 | SUPPORT POST (See Fig. 4) |
Use Hardware - - GROUP "C" | |
| CAUTION: Container support is spring |
| loaded and locked to the cover. Handle |
| cover assembly carefully so as not to |
| unlatch the cover from the container |
| support. |
1.Rotate cover assembly onto its side as shown.
2.Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely.
CARRIAGE
BOLTS
SUPPORT
POST
02091
LOCKNUTS
FIG. 4
7