Poulan C36C, 532140600 Container Mounting See Fig No hardware required, Use Hardware - Group E

7 CONTAINER MOUNTING (See Fig. 7)

No hardware required

1.Install one container to left side first with warning to outside of unit. Install other container to right side.

NOTE: Right container should always overlap left container at center support.

2.Close cover and lock latch handle over center support tube.

COVER LATCH

HANDLE

CONTAINER

WARNING

G NI RN A W

CONTAINER

HANDLE

CENTER

SUPPORT

TUBE

CONTAINER

02082 WARNING

FIG. 7

8	LOWER CHUTE (See Figs. 8A & 8B)
	Use Hardware - - GROUP "E"

1.Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, washer, and lock washer as shown.

2.Tighten hardware securely.

3.Raise and hold deflector shield in upright position.

4.Place front of chute over front of mower deck opening and slide into place, as shown.

5.Hook front latch into latch bolt on front of mower deck.

6.Hook rear latch into latch bolt on back of mower deck.

CAUTION: Do not remove discharge guard from mower.Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.

	WASHER
	WASHER
LOCK	LOCK WASHER
WASHER
	LATCH
LATCH	WELD
	NUT
WELD	SCREW
NUT
	FIG. 8A
	DEFLECTOR
	SHIELD

LATCH

HOOKS

FIG. 8B

9	CHUTE LATCH ASSEMBLY
	(See Fig. 9)

Use Hardware - - GROUPS "F & G"

1.Assemble latch pin to upper chute, as shown.

2.Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.

3.Tighten all hardware securely.

	WASHERS
#10 X 1-1/8" SCREW	3/16 X 3/4 X 16
	GA.
	SPLIT
	SPACER
UPPER CHUTE
	ACORN NUT
#10 X 5/8"
SCREW	RUBBER
	LATCH
LOWER CHUTE
	WELD
	NUT
WASHER	0
3/16 X 3/4 X 16 GA.	2102
	LOCK WASHER

FIG. 9

9