Omron V022-E3-1 Responding to Displayed Error Messages, Errors Occurring During Operation, 8-2-1

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿6￿￿￿￿.￿￿￿￿￿￿￿			Section 7-2
8-2	Responding to Displayed Error Messages
		When the NT600S displays an error message, find the corresponding symptoms
		in the appropriate table below and respond by following the “Remedy” indicated in
		the table.
8-2-1	Errors Occurring when the Power is Turned ON
		The table below shows the errors that can occur when the power supply to the
		NT600S is turned ON, and their remedies.
	Message	Cause	Remedy
The Screen Data		There is an error in the registered	After initializing the screen data memory in the
Corrupted		screen data.	Maintenance Mode, transmit the screen data once
			more with the support tool.
The Mark Data Corrupted		There is an error in the registered	After initializing the screen data memory in the
		mark data.	Maintenance Mode, transmit the screen data once
			more using the support tool.
Screen data is not		There is no screen data.	Transmit screen data from the support tool.
registered.
The counters of memory		There is an error in the memory	Press the [Confirm] touch switch. The NT600S
switches were corrupted.		switch settings.	restores the normal state, with the memory switch
			settings reset to the initial settings.
An error occurred in the		There is an error at the C200H	Contact your OMRON service center.
unit.		interface unit.
8-2-2	Errors Occurring During Operation
		The table below shows the errors that can occur during operation of the NT600S,
		and their remedies.
	Message	Cause	Remedy
Setting Error		Bits or words allocated to the PC	Check the memory area in the PC used and correct
		memory cannot be found in the	the bit and word allocations in the screen data.
		screen data.
I/O register command is		The PC model is one that does not	Check the model of the PC currently used to
not available or switch		allow connection of the NT600S.	determine whether the NT600S can be connected to it
settings are wrong.			or not; select a model to which the NT600S can be
			connected.
		Settings of the Host link unit are	Check the setting of the switches on the Host link unit.
		wrong.
8-2-3	Errors Occurring on Screen Data Initialization and Transfer
		The table below shows the errors that can occur when data is written to the
		NT600S screen data memory, and their remedies.
	Message	Cause	Remedy
Screen Initialization Error		Hardware fault or screen data	If the same message is displayed even after executing
		memory life reached	screen data memory initialization or screen data
			transmission several times, contact your OMRON
			service center.

￿￿￿