Omron V022-E3-1 operation manual Section, MEMORY INITIALIZATION MENU Quit, Memory Switches

%￿￿￿￿￿￿￿/￿￿￿.￿￿￿￿￿ Section 3-4

Reference If “No” is selected, the memory initialization will be canceled and the NT600S re- turns to the “Memory initialization”.

[ MEMORY INITIALIZATION MENU ]

Quit

Screen Data Memory

Memory Tables

Display History

Memory Switches

Upon completion of image data memory initialization, the NT600S returns to the “Memory Initialization Menu”.

After initialization of the screen data memory, the system enters the operation mode. At this point, nothing is displayed on the screen of the NT600S.

When the screen data memory initialization has been completed, transfer the screen data from the support tool.

If the screen data cannot be initialized for any reason, the message “An Error Oc- cur Initializing Memory” is displayed.

4-4-2 Initialization by Using the DIP Switch (Forced Initialization)

Note Be sure to turn the power OFF before setting the NT600S DIP switch.

Set the DIP switch as follows to initialize the screen data memory.

Operation 1. Set DIP SW2-1 on the NT600S to ON and turn the power ON.

Initialize the Screen Data Memory?

Confirm

Cancel

The screen data memory was initialized.

Turn off the DIP-Switch 2-1 and push the reset switch, then NT600S starts up normally.

Select “Confirm”. The screen data memory is initialized. Dur- ing the initialization, the “Initial- izing ...” message will be dis- played.

2.Turn the NT600S power to OFF.

3.Set NT600S DIP SW2-1 to OFF and turn the power ON.

￿￿