Omron V022-E3-1 operation manual Copy Memory Table, Section, Format, Description, Operation

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿&￿￿￿ Section 6-2

Copying the Memory Table Use the following command to change numerals or character-strings to be dis- played on the NT600S after copying the contents of a memory table.

Copy Memory Table

Format

[ESC]

1B

/ m1 s1 s2 s3 d1 d2 d3

2F

m1: Type of memory table

0 (30H): Character-string memory table

1 (31H): Numeral memory table

s1s2s3: Copy source memory table address (see table below)

d1d2d3: Copy destination memory table address (see table below)

	Character-string	Numeral memory table address
	memory table address
	000 to 255 (3-digit BCD)	000 to 511 (3-digit BCD)
Description
	Copies the contents of the copy source memory table to the copy destination
	memory table. The memory table contents are copied to a memory table of the
	same type: character-string memory table to character-string memory table or nu-
	meral table to numeral memory table.
Operation	1. Register the memory table - which contains the numerals or character-string
	to be displayed - for the screen when creating the screen data using the sup-
	port tool.

In the case of a character-string, use the “character-string display” mode of the support tool to specify the character-string memory table.

In the case of a numeral, use the “numeral display” mode of the support tool to specify the numeral memory table.

2.When creating the screen data using the support tool, set the copy source data in the memory table.

Use the “table edit” mode.

Reference This method can be conveniently used to switch the numeral or character-string display according to the operating status. If several sets of copy source data are prepared in advance, it is possible to display the data that matches the operating status.

￿￿￿