Omron V022-E3-1 operation manual 5-8-4Using Numeric Keys, Section

￿￿￿￿￿￿￿￿￿￿￿￿￿￿ Section 4-8

5-8-4 Using Numeric Keys

To input numerical data at a numeral setting area during operation, first select the numeral setting at which the data is to be input, and then input the numerical value by pressing the numeric keys (touch switches).

Selecting the Numeral Setting Area for Data Input

Select the numeral setting area into which the numerical value is to be input by ￿using either the numeric keys or the system keys.

Selection with the numeric keys

Use the [HOME], , , and keys. By using these keys, the cursor can be shifted between numeral setting areas in the way shown in the figure below.

6563

4568

5107

3200

HOME

0000

4624

Pressing the [HOME] key will shift the cursor to the area whose top left corner has the smallest XY coordinate sum (the top left numeral setting input field in the

￿example above).

Selection with the system keys

When the and system keys on the touch panel are pressed, the cursor moves between the numeral setting areas by following the order in which they were created using the support tool.

For example, if three numeral setting areas have been created, the cursor can be moved between them following the order of creation as follows.

key:1st area → 2nd area → 3rd area → 1st area key:1st area → 3rd area → 2nd area → 1st area

If the “numeral setting” screen attribute is set to “system”, the order of cursor motion when the and system keys are used can be changed. For details, refer to the NT series support tool operation manual (V028-E1-￿).

￿￿￿