Omron V022-E3-1 operation manual 4-5Registering the Screen Data, Section

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ Section 3-5

4-5 Registering the Screen Data

The screen data is created by using the support tool and registered to the NT600S screen data memory. This section describes the procedure to register the screen data to the NT600S. For the screen data creation and the support tool operation, refer to the NT-series Support Tool Operation Manual (V028-E1-￿).

Reference The screen data transmission speed can be increased by setting “Hispeed” for “Communication Mode” on the Tool Settings screen of the support tool.

Transmission -- Transmission in File Units

The NT600S uses several screens which are switched on its display. The screen data of one NT600S unit corresponds to the files created by using the support tool. Select a file which contains the screen data to be transmitted when selecting the screen data to be transmitted to the NT600S so that the required screen data can be transmitted to the NT600S.

Screen data file

Screen 1

Screen 2

:

Screen N

Memory table

Mark data

System memory

All screen data are transmitted by one operation.

NT600S

Screen 1

Screen 2

:

Screen N

Memory table

Mark data

System memory

Direct connection information

Direct connection information

Reference If an error message and the System Menu are displayed immediately after the

￿NT600S has been started, the screen data memory needs to be initialized.

Before transferring the screen data to the NT600S, initialize the image data memory.

￿￿