Omron V022-E3-1 operation manual $& Section, Making the PC system settings, Switchsettings CPM1

￿￿￿￿￿￿￿￿￿￿￿￿￿$￿￿￿￿￿&￿￿￿'￿￿( Section 2-4

[Making the PC system settings]

The possible settings and existing settings which can be set by the PC system set- ting are as given below.

Item	Possible Setting	Existing Setting
Baud rate	2400/4800/9600/19200 bps	9600 bps
Stop bit	1 or 2 stop bits	2 stop bits
Parity	Even/odd/non-parity	Even parity
Data length	ASCII 7 bits	ASCII 7 bits
￿Unit #	00 to 31	Unit #00

C-series C200HS, C200HX/HG/HE, CPM1, CQM1

Set the operating conditions to the PC system setting area when a C200HS or CQM1 CPU is connected to the NT600S. The PC system setting area (data memory) can be directly accessed from the peripheral tool (LSS etc.).

The following describes the switch settings so as to enable the PC system set- tings. For the details of the operation with the PC system setting area, refer to the “SYSMAC CQM1 Reference Manual” (W228-E1- ￿).

[Switch settings] (C200HS,￿C200HX/HG/HE, CQM1)

CPU unit DIP switch settings

RS-232C port communication condition settings

Set DIP switch 5 to OFF (right side) to enable the PC system settings.

[Switch￿settings] (CPM1)

CPM1

-CIF01CPM1

Set the mode setting switch to the “HOST” (upper) position.

[PC system setting area settings]

Write settings to the PC system setting area (data memory) according to the port used to connect to the NT600S.

Channel #	Writing Value	Settings
DM6645	0001	Host link mode and conditions are set.
	0303	Data length: 7 bits, 2 stop bits, even parity,
		baud rate: 9600 bps
DM6646
	0304	Data length: 7 bits, 2 stop bits, even parity,
		baud rate: 19200 bps
DM6648	0000	Unit No. 0

￿￿