Omron V022-E3-1 Preparing RS-232CConnector Cables, Appendix E, Connector Cover Assembly

.￿￿￿￿￿￿￿￿.￿(￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿$￿0&￿￿￿ Appendix E

Connector Cover Assembly

Assemble the connector covers as shown in the diagram below.

	Aluminum foil tape
End connected to FG	End not connected to FG

Preparing RS-232C Connector Cables

Prepare a connector cable to connect a NT600S to a HOST separated by more than 5 m so that the supplied con- nector cable (XW2Z-500P) cannot be used. The maximum cable length is 15 m.

Recommended Parts

Name	Model	Remarks
Connector	XM2A-0901	9-pin, manufactured by OMRON
Connector cover	XM2S-0911	9-pin, manufactured by OMRON
Cable	AWG28￿5P	Multicore cable, manufactured by Fujikura, Ltd.
	IFVV-SB
	CO-MA-VV-SB	Multicore cable, manufactured by Hitachi Cable, Ltd.
	5P￿28AWG

On the other end of the cable use the type of connector and connector cover which matches the host computer connector type.

Connection For Host	Only the shielded wire on the host side is connected to the connector hood. The
	following diagram is for RS/CS control. If RS/CS control is not executed, RS and
	CS must be short-circuited (turned over) for both the NT600S and host side.

NT600S

	Abbrevi-	Pin
	ation	number
	FG	1
	SD	2
	RD	3
RS-232C	RS	4
interface	CS	5
	+5V	6
	--	7
	--	8
	SG	9

HOST

PinAbbrevi-

number ation

1--

2RD

3SD

4	--	RS-232C
		interface

5SG

6--

7RS

8CS

Shielding wire

Note	For some host computers the combination of pin numbers and signal names may
	differ from those shown in the diagram above. Refer to the Host instruction manu-
	al before wiring the connector.

￿￿￿