Omron V022-E3-1 Inspection and Cleaning, Section, Cleaning Method, Inspection Method

%￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿			Section 7-4
8-4	Inspection and Cleaning
		Clean and inspect the NT600S regularly to ensure that it is always used in its opti-
		mum condition.
Cleaning Method		If the display is dirty the screen is difficult to see. Clean the screen from time to time
		as follows.
		In daily cleaning, wipe the display with a soft dry cloth.
		If the soiling cannot be removed with a dry cloth, wet the cloth with diluted neutral
		￿detergent (2%), wring it out well and wipe the display with it.
		If rubber or vinyl products, tape, etc. are left stuck to the display for long periods
		they will cause staining. If such items are stuck to the display, remove them dur-
		ing cleaning.
	Note
		Never use volatile solvents such as benzene or thinners, or chemical dusters.
		These could cause degeneration of the coatings of the NT600S display and body.
Inspection Method
		In normal environments, inspect the NT600S at intervals of between 6 months and
		a year. In environments that are extremely hot and humid, or very dusty environ-
		ments,￿	shorten the inspection interval.

Items required for the inspection

Prepare the following items before starting the inspection.

-The tools supplied with the NT600S

-Screwdrivers (Philips, flat-head)

-Tester (or digital voltmeter)

-Industrial alcohol

-100% cotton cloth

-Hygrometer (required in some cases)

-Thermometer (required in some cases)

-Synchroscope (required in some cases)

-Pen-writing oscilloscope (required in some cases)

￿￿￿