Omron V022-E3-1 operation manual 4-6-2Baud Rate Selection Host Link Only

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿-￿￿￿￿￿￿$￿0&￿￿￿￿1￿￿￿￿￿￿￿.￿￿￿￿￿￿-￿￿￿￿￿￿ Section 3-6

[ MEMORY SWITCH MENU (1/2) ]

Comm. Method	Host Link	EXIT
Key Press Sound	OFF	NEXT
Buzzer Sound	OFF
		PAGE
Putting-Out Time	None	SAVE
Resume Function	ON
Support Tool Mode	NT600S	EXIT

Each time the “Comm. Method” touch switch is pressed, the set- ting option changes to the next item in the sequence “Host Link”, “NT Link”, “NT Link 1:N”, “RS-232C”.

When a C200H interface unit is connected, the setting is fixed as “C200H”.

To set and quit the menu, press the [SAVE EXIT] touch switch. To quit without set- ting, press [EXIT].

4-6-2 Baud Rate Selection (Host Link Only)

When using the host link, the baud rate for the communication method must be set. “9600 bps” or “19200 bps” can be selected.

The factory setting has been made at 9600 bps.

Select the baud rate of the communication with the PC by the menu operation from the System Menu shown below.

[ SYSTEM MENU ] Quit

Transmit Mode Maintenance Mode

Select “Maintenance Mode”.

	Select “Memory Switches”.
[ MAINTENANCE MENU ]
Quit	Display History
PT Setting Status
I/O Check
Memory Init.
Memory Switches

￿￿