Omron V022-E3-1 operation manual Appendix H, Parts Required, Wiring Connections

.￿(￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ Appendix H

APPENDIX H

Making the Cable for Connection to the Support Tool

Make the connection cable for connection to the support tool by referring to the following explanation.

Parts Required

The table below indicates the recommended parts for making the connection cable.

Name	Model	Remarks
Connector	XM2A-2501	25-pin, manufactured by OMRON
	XM2A-0901	9-pin (Plug), manufactured by OMRON
	XM2D-0901	9-pin (Socket), manufactured by OMRON
Connector cover	XM2S-2511	25-pin, manufactured by OMRON
	XM2S-0901	9-pin, manufactured by OMRON
Cable	AWG28￿5P	Multicore cable, manufactured by Fujikura, Ltd
	IFVV-SB
	CO-MA-VV-SB	Multicore cable, manufactured by Hitachi Cable, Ltd
	5P￿28AWG

The recommended parts listed above are those applicable when the personal computer features a 25-pin DSub female connector. If the personal computer features another type of connector, prepare the appropriate parts by referring to its manual.

Wiring Connections

The connector at the NT600S used for connecting the support tool is also used as the connector for connecting the PC/Host.

For the pin configuration, refer to NT600S Connector Specifications (page 267). The￿wiring connection is shown below.

With a 25-pin Connector

NT600S

	Abbrevi-	Pin
	ation	number
	FG	1
	SD	2
	RD	3
RS-232C	RS	4
interface	CS	5
	+5V	6
	--	7
	--	8
	SG	9

Shielding wire

PC (RS-232C 25pin connector)

Pin	Abbrevi-
number	ation

1FG

2SD

3RD

4	RS	RS-232C
		interface

5CS

6--

7SG

8--

-- --

----

----

----

20 ER

Note	For some host computers the combination of pin numbers and signal names may
	differ from those shown in the diagram above. Refer to the Host instruction manu-
	al before wiring the connector.

￿￿￿