Transmission in Screen Units

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Section 3-5

Transmission in Screen Units

The NT600S allows the transmission of data for individual screens. The screen number of the screen to be transmitted can be specified with the support tool to transmit this screen only to the NT600S (it is also possible to transmit multiple screens in a batch).

If, when executing screen data transmission in screen units, there are also changes to data other than screen data, for example memory table or direct ac- cess data, transmit this changed data to the NT600S also.

Screen N Memory table (Direct information) Caution

Reference

Support tool

NT600S

Screen 1

 

Screen 2

Screen 2

Only the required data is transmitted.

Screen N Memory table (Direct information)

When screen data transmission is in screen units, if data other than screen data changes -- for example memory table or direct access data -- transmit this new data also.

When screen data is transmitted to the NT600S, it does not overwrite existing screen data; it is written to a free area of the memory. Consequently, if data is transmitted frequently in screen units, the free area of the memory will not be suffi- cient and transfer will become impossible. If this happens, transmit the data in file units to bring the memory of the NT600s back to order.

Transmitting the Screen Data from the Support Tool

To transmit the screen data from the support tool to the NT600S, connect the NT600S to the computer on which the support tool is being used, and follow the procedure below.

Reference The NT600S (Host link/NT link/RS-232C method) uses one connector for the con- nection to both a PC/Host and a computer. If it has been connected to a PC/Host, disconnect the PC and connect the support tool (computer) to the NT600S, and then, transmit the screen data.

Operation 1. Connect the NT600S to the computer on which the support tool is being used, and turn ON the NT600S.

2.Turn ON the computer and start up the support tool.

3.Set the [Support Tool Mode] memory switch setting to match the support tool being used.

￿￿

Page 94
Image 94
Omron V022-E3-1 operation manual Section, Transmission in Screen Units, Reference, Support tool, NT600S