Omron V022-E3-1 operation manual Section, Removing the unit, out while keeping a firm grip

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿$￿-￿￿￿￿"￿￿&￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿		Section 2-7
Removing the unit	As shown in the figure below, grasp the unit by the cutouts at either side, then pull it
	out while keeping a firm grip.

C200H Interface Unit Switch Settings

Set all the DIP switches (SW1, SW2) of the C200H interface unit to “OFF” (re- served for system use) and set the unit number to 0 with the rotary switch (SW3).

It is necessary to set a machine number for NT600S since it operates as a high- level function I/O unit of C200H. Make sure that the machine number to be allo- cated is unique.

Switch cover

SW1 SW2 SW3

The DIP switches are located under the switch cover on the front of the interface unit.

When using C200H/HS, or C200HX/HG/HE, the words corresponding to the channel numbers indicated below are occupied for each unit number set. Howev- er, since the NT600S uses the allocated bits and words for processing, it does not use these words.

These words are used as internal auxiliary relays.

Unit No.	Channel #
0	100 to 109
1	110 to 119
2	120 to 129
3	130 to 139
4	140 to 149
5	150 to 159
6	160 to 169
7	170 to 179
8 (*)	180 to 189
9 (*)	190 to 199
(*) Cannot be set with C	H.

￿￿