Omron V022-E3-1 2-7Before Operating, Section, When using Host Link/NT Link/RS-232C, Reference

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿ Section 1-7

2-7 Before Operating

Follow the procedure given below to start the system of the NT600S.

When using Host Link/NT Link/RS-232C

Host

PC

NT600S

Support tool

Check and change the￿PC settings.

For the host link, refer to page 31 and the manuals for the host link unit and peripheral tools.

For the NT link (1:1), refer to page 43. For the NT link (1:N), refer to page 47.

No special setting re- quired for C200H di-

￿rect communication For RS-232C: Refer to page 63 Refer to the manuals supplied with the Host.

Set the DIP switches.

(page 26)

Install to the operation panel.

(page 27)

Connect the power supply.

(page 28)

Check and change the	Connect to the
connection at the Host.	NT600S.
(page 31)
Refer to the manuals
supplied with the Host.

Create the Host	Create the PC
program.	program.
Refer to Section 6.
Refer to the manuals
supplied with the Host.

Start operation.

Connect to the PC.

(Host link: page 31)

(NT link (1:1): page 43)

(NT link (1:N): page 47) (C200H direct commu-

￿nication: page 56)

(RS-232C: page 63)

Check the settings		Install support tools to
and communications.		the computer.
		Create the screens.
	Transfer the	(refer to Section 4 and the
	screen data.
		manuals for the support
	(page 79)
		tools)

Note	Before starting actual operation, check the screen data and the program to be run
	at the Host completely for its operation.
Reference
	For usable support tools, refer to Appendix H Making the Cable for Connection to
	the Support Tool (page 278)

￿￿