(2)Remove the cover by grasping the knob on the top of the cover.
Fixing hole (rear)
*Screw (M3x8, 5 pcs.)
Slide forward
Knob* 
* 
* | * |
Screw (M4x8, 2 pcs.) |
Fixing hole (front) |
Figure 1-11 How to dismount the PTU cover
9.Fasten the display unit to the mounting location at rear fixing holes (2 points) with M10 bolts, nuts and flat washers, using the pipe box spanner (supplied)
10.Close the PTU board cover.
11.Push the monitor forward until you hear a click. 12.Refasten the bolts removed at step 3.
13.Fix the left and right arm covers.
Console type mounting
1.Make six holes of 15 mm diameter and a cable entrance hole through the deck referring to the outline drawing at end of this manual.
2.Open the front cover.
3.Fix the equipment by using M12 bolts, nuts and washers.
4.Hoist the console to the deck by using the eye bolts attached to the console. Remove the eye bolts and set the cosmetic caps (w/washers) to the eye bolt holes.
