4.Replace the cable assy. with cable assy.
5. Attach warning label to the bottom plate.
P312 FX Connector
KB | BOTTOM |
| |
PLATE | |
Upset Screw
M6X12 (2 pcs.)
KB Clamp
Handle
Attach warning label
J314 | J317 | (underside) | |
| |||
J312 |
|
| |
| (underside) | ||
|
| ||
| (underside) | ||
Earth Wire
P314 XH3P
Screw
M4X8 (8 pcs.)
Lay cable in slot.
Replace with | Spacer |
cable assy. in | Be careful not to pinch cable between |
kit. | KB clamp and spacer. |
Figure 1-14 Control head
Connection of display unit to control head
1.Attach the handle to the handle plate, using the screws for the handle and bottom cover of the control head.
2.Attach the handle plate to location where the KB arms were fastened.
3.Pull the monitor toward you until you hear click.
4.Lead in the cable assy. (option) from the rear entrance of the display unit. See Chapter 2.
5.Raise the monitor and fix the stay.
6.Inside the display unit, fasten ground wire of the cable assembly with an M4 screw on the chassis.
