trouble shooting
Problem | Check that... |
There are no lights on the unit | < the power cord is plugged into the AVR600 and the mains socket it is |
| plugged into is switched on. |
| < the power button is pressed in. |
| If a red LED is present, the AVR600 is in standby mode. Press any button on the |
| front panel or remote control. |
The unit responds erratically | < there are fresh batteries in the remote control. |
or not at all to the remote | < the front panel window is visible and you are pointing the remote control |
control | towards it. |
The front panel display is | < the display hasn’t been turned off. Press the DISPLAY button on the front |
blank | panel or remote control. |
No picture is being produced | < your viewing device is turned on and switched to display your AVR600. Test |
| by pressing the MENU button on the AVR600 or on the remote and look for |
| the main menu screen on your display device. |
| < the correct video input is selected on the AVR600. |
| < the video source is on, is operating normally, and is in ‘play’ mode if |
| appropriate. |
| < you have the AVR600 in a video resolution that is compatible with the |
| connection you are using and with your display device. For example, |
| composite video is only capable of carrying 480i and 576i resolutions. Test |
| this by pressing and holding the OK key for more than two seconds to force |
| 480i / 576i output resolutions. |
There are bright edges or | < the cables used for analogue video connections are designed to carry video |
‘ghosts’ on the picture | (i.e., they are 75Ω coaxial cables). |
| < ensure the ‘sharpness’ control on your display device is switched off or set to |
| near minimum. |
| < for HDMI connections, try using a shorter cable or alternatively a different |
| brand. |
No sound is produced | < the correct input has been selected. |
| < the source equipment is on, is operating normally and is in ‘play’ mode if |
| appropriate. |
| < the volume is turned up to a reasonable level and the AVR600 is not in mute |
| mode. |
The sound is poor or distorted < you have not excessively increased the input sensitivity (i.e. reduced the maximum input signal voltage) in the Input Config. menu if an analogue input is being used.
<you have selected the correct size of speakers to suit your system in the setup menu.