Zone 3 connectors
��
���
| � | � | Z3 OUT |
| � | � | |
| Connect these analogue audio | ||
|
|
| |
�� | �� | �� | outputs to your Zone 3 equipment. |
| ��� | ||
| �� | �� | See |
| for information. | ||
|
|
| |
| � | � |
|
��� �� | �� |
| |
��� |
| ||
| �� | �� |
|
|
| �� |
|
� | � | ����� | |
��� |
| ||
|
| �� |
|
|
| ����� | |
|
| ��� |
|
|
| �� |
|
|
| ��� |
|
|
| ��� | ������������ |
|
|
| |
|
| ��� |
|
|
| ��� |
|
Zone 2 connectors
Z2 AUDIO OUT, Z2 VIDEO OUTConnect these analogue audio and video outputs to your Zone 2 equipment. See ‘Multi- room Setup’ on page 48 for information.
����
��
��
���
���
���
���
��������������������
Digital audio connectors
TAPE, CD, AV, DVD, SAT, VCR, PVR
Connect these inputs to the digital outputs of your available source equipment.
English
| � | � | Component/RGB |
|
|
| |
��� | �� | �� | video connectors |
| ��� | ||
|
|
| |
| �� | �� | These inputs are suitable for |
|
|
| |
|
| ��������������� | connection to source devices |
|
|
|
Connect the Component video outputs of your source
��� |
|
��� | ��� |
���� |
|
������� ��������� |
|
S-Video and Composite connectors
������� |
| ��� | OPTICAL, COAX |
���� |
| Connect the optical or coaxial output | |
|
| ||
|
|
| |
|
|
| to your digital recording device such as |
which output Component (YUV or YPbPr) or RGB high quality analogue video signals. These
signals are usually available from DVD players,
If you are connecting up to an RGB source you will also need to connect the source’s Composite output to the AVR600 Composite input to act as a video sync. The Composite signal should be on the same named input as the RGB signals.
RGB video outputs on source equipment are often on SCART connectors. You will need to use a SCART to ‘RGB+Sync on phono’ breakout cable, available from your Arcam dealer.
NOTE
When setting up the AVR600 menus (later in this manual), you will need to select whether the three- wire high quality video input is Component or RGB for each input. This is done on the ‘HQ Video In’ line in the Input Config menu. Failure to do this can result in a green looking picture or a picture that is unstable.
equipment to these inputs.
OUT
Connect this output to the Component video input of your display device.
NOTE
Analogue RGB video output is not available from the AVR600. The analogue
AV, DVD, SAT, VCR, PVR
Connect these inputs to the
of your available source equipment.
VCR OUT, PVR OUT,These are recording outputs. Connect these to the
Connect this output to the
When a digital source is selected, the digital output will send an exact
copy of the incoming digital signal. For example, for a
5.1digital source, the digital output will also be in 5.1 format.
When an
These outputs are muted if a source is selected where the HDMI connection is used and is transmitting HD audio. The digital audio from the HDMI link will not be routed to these outputs.