INSTALLATION
The CAS Series of
Tools Needed
PENCIL | #2 PHILLIPS SCREWDRIVER |
MEASURING TAPE | UTILITY KNIFE |
CARPENTER’S LEVEL
Installation Instructions
Step 1
After removing all parts from the box, locate the supplied template and use it to trace a pattern on the wall where you want to mount the speaker system. Take care to locate the system roughly centered between wall studs, allowing at least 1" between the cutout and wall studs. Cut the mounting hole, being careful not to cut into any electrical wiring or plumbing. Run the wiring from your system to the hole. NOTE: Be sure to comply with local wiring codes.
Step 2
Note that the CAS 3.1 and CAS 2.1 speakers come with the baffle assembly attached to the mounting frame at its four corners to prevent damage during shipping. Unscrew the four screws as shown and carefully lift the baffle assembly out of the mounting frame. Note that the CAS 3.1 and CAS 2.1 speakers are designed for IR connectivity. The IR lens cover is
SCREWS
INSERTS
BAFFLE ASSEMBLY
MOUNTING FRAME
IR Sensor
The CAS 3.1 and CAS 2.1 speakers are designed for IR connectivity. The IR lens cover is located on the front of the speaker assembly and a place for mounting the sensor (not included) is located behind this lens on the crossover network board. See your IR instructions for specific installation recommendations.
Step 3 (optional)
If the grilles are going to be painted, it is necessary to remove the cloth behind the grille by lifting the edges of the cloth from the center and pulling it out. After painting the grille, replace the cloth. Also, remove the logo from the grille. Extra logos are provided to attach to the grille after the paint has dried.
located on the front of the SPEAKER ASSEMBLY and a place for |
| |
mounting the sensor is located behind this lens on the crossover |
| |
network board. See your IR instructions for specific installation | 5 | |
recommendations. | CAS 3.1/CAS 2.1 | |