Infinity CAS 3.1 manual For Removal, Pull out side clips on sides of the grille. Pull grille off

Page 8

Step 6

Insert the four rubber grommets that retain the grille posts into the screw hole on the front, as shown. The grille has two side clips that look like wings. These extend about 1/4". See illustration. Note the side flange areas that catch the clips. Make sure these side clips are extended before attaching or removing the grille. Extend the side clips and attach the grille, reclipping it once in place.These side clips push inward to lock the grille onto the speaker.

NOTE THAT THE

SIDE CLIPS ARE

PULLED OUT 1/4"

SIDE FLANGE

AREAS

GROMMET

GRILLE

For Removal

Step 1a

Pull out side clips on sides of the grille. Pull grille off.

Step 2a

Remove the rubber grommets from the holes to access screws. It is best to use a #2 Phillips screwdriver to gently pry the grommet out. Unscrew the four baffle-retaining screws

and carefully remove the speaker housing. Disconnect the speaker wires.

Step 3a

Fully unscrew all of the clamps around the speaker housing. The clamp screws have a stop on them so you do not have to worry about accidental disassembly. Now move the speaker housing out from the wall enough to wedge your hand behind and pinch a clamp shut. While the clamp is shut, work the speaker housing forward enough to catch the shut clamp in the wall opening. Work your way around the perimeter, carefully doing this to each clamp and remove the speaker housing from the wall.

8CAS 3.1/CAS 2.1

Image 8
Contents CAS 3.1 and CAS Technology Unpacking the Product IncludedPlacement Speakers are installed withSurround Channels in a Home Theater System Such as during a partyInstallation Installation Instructions StepTools Needed IR SensorClampscrew Wall Fiberglass Insulation Mounting Frame For Removal Pull out side clips on sides of the grille. Pull grille offStandard Wiring BI-WIRING Single-Stereo AmplifierThiele/Small Parameters Installer InformationEnclosures Specifications Dimensions