Robic SC-848W-300 warranty How to Determine and Enter the Distance, Enter Distance

Page 9

TIME OUT: Your chronograph has a time-out feature. If the event being timed is stopped for any reason, press “A” to stop timing, restart by pressing “A”. All previously recorded data will be stored in memory (up to 300 laps).

Part 6 SPEED TIMER OPERATION

The Speed Timer will compute and display speed in MPH/KPH as a function of distance and time. To enter the Speed Timer mode from normal time, press “E” four times. If the Speed Timer is running, stop timing by pressing “A” once. Reset the display to all zeros by pressing “B” for two seconds. The display will show:

[000] 00:00’00”00

SPEEd

0.250

 

 

DIST MI

 

00:00’00”00

The Speed Timer will not operate unless the Chronograph is stopped and Reset to all zeros. STOP indicator will appear.

How to Determine and Enter the Distance.

The first step is to enter the distance correctly. The speed timer will not work unless a distance is entered.

Distance is entered as the decimal equivalent of a mile or kilometer from 000.001 to 999.999. For example, enter 2 ½ miles/kilometers as 002.500, 1/3 as 000.333, 1/8 as 000.125, etc.

You may convert feet to the decimal equivalent of a mile, i.e., 187 feet is entered as 000.035 (187 divided by 5280 = 000.035)

Convert meters to kilometers as follows: 230 meters is entered as 000.230 (230 divided by 1000 = 000.230).

Enter Distance.

To enter the distance when the timer is stopped and reset to zeros, press and hold “F” for three (3) seconds until SET appears in the bracket on the top row of this display and UNIT appears flashing above the upper row of digits in the display.

MI or KM will also appear flashing between the middle and lower rows of the display. Press “A” until the desired unit of measurement (mile or km) appears.

Press “B” and the first digit of the distance value located in the middle row (000.000) appears flashing. Advance the digit (0-9) by pressing or holding “A” until the desired

Image 9
Contents Robic SC-848W Operating Instructions Part Pushbutton and Indicator Location and OperationRecall Memory Mode SequenceSpeed Timer-Press E Chronograph Stopwatch-Press EEL Backlight Operation Part 2 Normal Time Operation Audible Beep CONFIRMATION-HOURLY ChimePart 4 Countdown Timers Operation Part 3 Alarm Time OperationTimertr Select Lap or Split in Row Part 5- Chronograph Stopwatch OperationSelect Recall Up or Down Timing Single Lap EventsAdvanced Functions Timing Multiple Lap/Split EventsEnter Distance How to Determine and Enter the DistanceImportant NOTICE--- Error Indicator One Lap Event START/STOP/RESETReset Multiple Lap Event TimingMax Slow Average and Memory Recall Max Slow Average Lap Speed & TimeMemory Recall Part 7 Stroke Rate Calculator