RIDGID RD80763 Attaching the wheel assembly, Support Foot, Attaching the trigger handle rest

Page 10

ASSEMBLY

attaching the wheel assembly and

SUPPORT FOOT

See Figures 3 and 4.

nLocate the support feet, nuts, and bolts.

nLift the machine and slide the support feet into the machine base.

nSecure in place using the bolts and nuts.

nLocate the axle, hitch pins, washer, and wheels. Remove the hitch pin from the axle.

nSlide the axle through the hole in the center of the wheel.

nSlide the washer onto the axle.

nLift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.

nPush the hitch pin into the hole on the end of the axle to secure the wheel assembly.

NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.

nRepeat with the second wheel.

attaching the trigger handle rest

See Figure 5.

nLocate the trigger handle rest (front and back), screws, flat washer, and lock nut.

nPush the screws into the holes. Tighten securely using the lock nut.

RAISING AND LOWERING the handle

See Figure 6.

nTo raise the handle: pull the handle up until the handle knob snaps through the locking hole to secure the handle in place.

nTo lower the handle: pull the handle knob out then lower the handle to the position shown in figure 6.

CAUTION:

Failure to remove pump oil plug label may result in decreased pump life.

REMOVE the LABEL

See Figure 6.

Remove pump oil cap label from the oil pump.

nut

support foot

bolts

Fig. 4

TRIGGER HANDLE

REST (BACK)

SCREW

SCREW

LOCK

NUT

flaT

washer

		Fig. 5
		raising and lowering handle
	handle	handle
	knob	handle
	knob

label

Fig. 6

10

Image 10

Contents OPERATOR’S Manual RD80763/RD80964Table of Contents IntroductionImportant Safety Instructions Read ALL InstructionsSpecific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Symbol Signal MeaningMax. rating determined by Pwma Standard FeaturesProduct Specifications RecoilAssembly Axle Attaching the rear panelHandle Torx Screw Rear panel Washer wheel hitch pinAttaching the trigger handle rest Attaching the wheel assemblySupport Foot Raising and Lowering the handleAttaching the auxiliary handle Connecting high pressure hose toAssembling the trigger handle Trigger HandleFunnel Adding oil to the engineAdding gasoline to the Fuel tank OIL CAP / Dipstick FunnelOperation Connecting the garden hose to the pressure washerConnecting the high pressure hose to the pump To connect the garden hose to the machineStarting and stopping the pressure washer Engine SwitchApplications See Figures 14Operation Using the spray wand triggerUsing the Nozzles SeeWashing with detergent See Figures 20Rinsing with the pressure washer Moving the pressure washerCleaning the air filter MaintenanceGeneral Maintenance AIR Filter CoverChanging the OIL Nozzle maintenanceChecking a fouled spark plug Storing the pressure washer Pump maintenancePreparing for use after storage Troubleshooting Problem Cause SolutionPage Warranty Federal Emissions Component Defect WarrantyGeneral Emissions Warranty Coverage High Altitude Engine Operation Warranty Periods Limited 3 Year Engine Warranty for Ridgid Pressure WasherLimited Manufacturer’s Warranty from Subaru Robin Rely on Subaru Robin ReliabilityWhat is not Covered Ridgid Pressure Washer 3 Year Limited WarrantyWhat is Covered Under the 3 Year Limited Warranty HOW to Obtain ServiceRD80763 / RD80964 Customer Service InformationModel No RD80763 / RD80964 Serial No