Scag Power Equipment SFW36-16BV manual Safety and Instructional Decals, Riding Attachments

Page 11

Section 2

R

2.7 SAFETY AND INSTRUCTIONAL DECALS

WARNING

DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING kIT, OR ENTIRE GRASS CATCHER INSTALLED

483405

WARNING

INSTALL BELT COvER BEFORE

OPERATING MACHINE

READ OPERATOR'S MANUAL

483405

WARNING

ROTATING BLADES AND BELTS

*keep hands, feet & clothing clear

*keep all guards in place

*Shut off engine & disengage blade clutch before servicing

*Use caution in directing discharge

*Read instruction manual before operating

DO NOT OPERATE UNLESS GRASS CATCHER, MULCHING kIT OR

DISCHARGE CHUTE IS INSTALLED 483406

483406

483402

SPINNING BLADES

kEEP CLEAR

BLADE CONTACT & THROWN

OBJECTS CAN INJURE

483505

483505

WARNING

Operation of this equipment may create sparks that can start ￿res around dry vegetation. A spark arrestor may be required. The operator should contact local ￿re agencies for laws or regulations relating to ￿re prevention requirements.

483900

483900 (supplied with California models only)

MOUNT RIDING ATTACHMENT HERE

WARNING

FALLING HAzARD

USE ONLY SCAG APPROvED

RIDING ATTACHMENTS

SEE OPERATOR'S MANUAL 483404

!CAUTION

Avoid injury from burns. Shut off engine before removing fuel tank cap.

483404

Molded in Fuel Tank

WARNING

BEFORE OPERATING

*Read operator's manual

*Solicite etiquetas en espanol a un distribuidor Scag

*Make sure guards, shields

&safety devices are in place & working

*Clear area of children, bystanders & debris

*Mow across face of slopes *Trained operators only

483907

 

483907

2009 SFW Safety Decals

7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents
OPERATOR’S Manual Always Follow Osha Approved Operation Remember Your Mower is only AS Safe AS the OperatorTable of Contents Inside Back Cover Limited Warranty SFWServicing The Engine And Drive Train Components General InformationIntroduction Direction ReferenceSTT Models Symbols Signal Word Safety Information Signal Words This symbol means Attention! Become Alert! YourOperation Considerations Maintenance Considerations & storage Using a spark arrestor Riding Attachments Safety and Instructional DecalsInstall Belt COvER Before Falling HAzARD USE only Scag APPROvEDEngine Deck SpecificationsEngine ElectricalProductivity Weights and DimensionsControls and Instrument Identification Operating InstructionsFirst Day of Use or Approximately 20 Hours Safety Interlock SystemInitial RUN-IN Procedures Starting the EngineReverse Travel Ground Travel and SteeringForward Travel Parking the Mower Engaging the Deck Drive Cutter Hillside Operation BladesMoving Mower with Engine Stopped Rotating BladesAfter Operation Removing Clogged MaterialCutting Height Adjusting Cutting HeightCondition Cause Cure Troubleshooting Cutting ConditionsTroubleshooting Cutting Conditions Contd Cutting path Scalping Blades HittingDirt or CuttingVery Close To the Ground Step Cut Ridge in CenterCutter Deck Adjustments AdjustmentsDrive Control Adjustments Belt AdjustmentCutter Deck Pitch Electric clutch adjustmentIf the air gap is too narrow, the clutch armature may drag Procedure Comments Break-In 100 200 500 First MaintenanceMaintenance Chart Recommended Service Intervals Lubrication Maintenance Chart Recommended Service Intervals ContdEngine Fuel System Engine OilCutter Blades Engine Air CleanerDrive Belts Blade Sharpening Blade ReplacementTires Scag Approved Attachments and Accessories Illustrated Parts ListCutter Deck 462150 Cutter Deck Weldment w/Decals 14 20 1217 462149 Cutter Deck Weldment w/Decals Cutter Deck Controls Cutter Deck Controls Handle Assembly Pulley, Jackshaft 3.25 OD x .625 Bore Engine Deck Description Electrical System and Throttle Control Ref. No Description Do not Operate Unless Grass CATCHER, Mulching kIT or Replacement Decals and Information PlatesSpinning Blades Rotating Blades and Belts1 2 3 SFW Electrical Schematic Limited Warranty SFW
Related manuals
Manual 18 pages 62.01 Kb
Top Page Image Contents