R
Section 5
TROUBLESHOOTING CUTTING CONDITIONS (CONT'D)
Condition | Cause | Cure |
Scalping - Blades Hitting | Low tire pressures | Check and adjust pressures |
Dirt or CuttingVery Close |
|
|
to the Ground | Ground speed too fast | Slow speed to adjust for conditions |
| ||
|
| May need to reduce ground speed, raise |
| Cutting too low | cutting height, change direction of cut, |
|
| and/or change pitch and level |
|
| May need to reduce ground speed, raise |
| Rough terrain | cutting height, and/or change direction |
|
| of cut |
Width of Deck | Ground speed too fast | Slow speed to adjust for conditions |
| ||
SGB022 |
|
|
| Wet grass | Cut grass after it has dried out |
Step Cut - Ridge in Center | Blades not mounted evenly | Adjust pitch and level |
of Cutting path |
|
|
| Bent blade | Replace blade |
| Internal spindle failure | See your authorized SCAG dealer |
| Mounting of spindle incorrect | See your authorized SCAG dealer |
Width of Deck |
|
|
SGB024 |
|
|
Slope Cut - Sloping Ridges | Bent spindle mounting area | See your authorized SCAG dealer |
Across Width of Cutting |
|
|
Path | Internal spindle failure | See your authorized SCAG dealer |
|
Bent deck housing | See your authorized SCAG dealer |
Width of Deck
SGB025
22