Scag Power Equipment STT61V-25CH-LP, STT52V-25CH-LP operating instructions Seat Belt Inspection

Page 11

Section 2

R

The potential exposure of the seat belt to severe environmental conditions make it crucial to inspect the seat belt system regularly.

It is recommended that the seat belt be inspected on a daily basis for signs of damage. Any seat belt system that shows cuts, fraying, extreme or unusual wear, significant discoloration due to UV exposure, dirt or stiffness, abrasion to the seat belt webbing, or damage to the buckle, latch plate, hardware or any other obvious problem should be replaced immediately.

WARNING

Failure to properly inspect and maintain the seat belt can cause serious injury or loss of life.

1.Check the full length of the seat belt webbing for cuts, wear, fraying, dirt and stiffness. See Figure 2-3.

2.Check the seat belt webbing in areas exposed to ultra violet rays from the sun or extreme dust or dirt. If the original color of the webbing in these areas is extremely faded and/or is packed with dirt, the physical strength of this webbing may have deteriorated. If this condition exists, replace the seat belt system.

3.Check the buckle and latch for proper operation and determine if the latch plate is excessively worn, deformed, or if the buckle is damaged or cracked. See Figure 2-3.

INSPECT BUCkLE

& LATCH

INSPECT WEBBING

Figure 2-3. Seat Belt Inspection

7

20o

15o

10o

5o

Figure 2-4.

WARNING

Reduce speed when turning, operating on slopes, slick or wet surfaces. Allow extra distance to stop.

Stay off of slopes too steep for safe operation. To check a slope, attempt to back up it (with the cutter deck down). If the machine can not back up the slope without the wheels slipping, do not operate the machine on this slope. Under no circumstances should the machine be operated on slopes greater than 15 degrees. See Figure 2-4 to determine approximate slope.

DO NOT mow near drop-offs, ditches or embankments. The machine could suddenly roll over if a wheel goes over the edge or if the edge caves in.

Operate the machine smoothly, no sudden turns, starts or stops on a slope.

NEVER tow on slopes. The weight of the towed equipment may cause loss of traction and loss of control.

DO NOT permit untrained personnel to operate the machine.

Be cautious when loading and unloading onto trailers or trucks.

Use only a full width ramp.

Ramp angle should be no more than 15 Degrees. See Figure 2-4 to help determine approximate slope.

Back up the ramp and drive down forward.

Page 10 Page 12
Image 11
Page 10 Page 12
Contents OPERATOR’S Manual STT61V-25CH-LP Remember Your Mower is only AS Safe AS the OperatorTable of Contents Inside Back Cover Troubleshooting Cutting Conditions AdjustmentsServicing The Engine And Drive Train Components General InformationIntroduction Direction ReferenceSymbol Description SymbolsBefore Operation Considerations Safety InformationSignal Words Operation Considerations Know the function of all controls and how to stop quicklySection Foldable Roll-Over Protection System Roll-Over Protection SystemSeat Belt Inspection SPARK Ignition System Maintenance Considerations & StorageUsing a spark arrestor Section Electrical SpecificationsPower Head EngineProductivity 52V 61V Weights And Dimensions 52V 61VCutter Deck Hydraulic SystemControls And Instrument Identification Operating InstructionsInitial Run-In Procedures Safety Interlock SystemForward Travel Starting The EngineGround Travel And Steering Reverse Travel Engaging The Deck Drive Cutter BladesAfter Operation Rotating BladesHillside Operation Parking The MowerRecommendations For Mowing Adjusting Cutting HeightMoving Mower With Engine Stopped Adjusting The Height Adjust Pedal Adjusting The Steering LeversTowing Optional Hitch Accessory Condition Cause Cure Troubleshooting Cutting ConditionsCut, or Rough Contour Troubleshooting Cutting Conditions ContdScalping Blades Hitting Parking Brake Adjustment AdjustmentsNeutral Adjustment Travel AdjustmentsTracking Adjustment Throttle Control and Choke AdjustmentsCutter Deck Pitch Cutter Deck LevelCutter Deck Height Cutter Deck Height AdjustmentCustom-Cut Baffle Adjustment Custom-Cut Baffle Adjustment10. Clutch Air Gap Adjustment Electric clutch adjustmentMaintenance Chart Recommended Service Intervals MaintenanceLubrication Maintenance Chart Recommended Service Intervals ContdLubrication Fitting Points Changing Hydraulic Oil Checking Hydraulic Oil LevelEngine Fuel System Engine OilCleaning and/or Replacing Air Cleaner Element Engine Air CleanerBattery Jump Starting Charging the BatteryDrive Belts Blade Sharpening Blade ReplacementCutter Blades Blade InspectionChecking Lubricant Level Cutter Deck GearboxTires Changing Lubricant Body, Deck, And UpholsteryScag Approved Attachments and Accessories Illustrated Parts ListSection Section Description 52V Cutter DeckSection 61V Cutter Deck 461863 Cutter Deck Velocity Plus Cutter Deck Controls 481764 Link, Deck Lift Sheet Metal Components 9278 STT ROLL-OVER Protection System STT ROLL-OVER Protection System STT Suspension Seat Section Deck Drive Components Bolt, Hex Head 3/8-16 x Engine and Attaching Parts Kohler LP Available through the individual engine manufacturer Brake and Steering Components Bolt, Carriage 5/16-18 x Hydraulic System Kohler LP Base LP System Kohler Available through the individual engine manufacturer BDP-16A Hydraulic Pump Assembly BDP-16A Hydraulic Pump Assembly Electrical System Kohler LP Electrical System Kohler LP Heavy-Duty Replacement Decals and Information Plates Electrical Schematic Kohler LP Limited Warranty Commercial Equipment

STT61V-25CH-LP, STT52V-25CH-LP specifications

Scag Power Equipment has long been synonymous with durability and performance in the lawn care industry, and their STT52V-25CH-LP and STT61V-25CH-LP mowers exemplify this commitment. Both models are part of the Scag Turf Tiger II series, designed for commercial landscapers and serious homeowners who demand the best in cutting efficiency and reliability.

The STT52V-25CH-LP features a 52-inch cutting deck, while the STT61V-25CH-LP boasts a 61-inch deck, allowing users to choose according to the size of their lawn or landscape maintenance requirements. The decks are constructed from high-strength steel, ensuring longer life and resistance to wear from heavy use. The signature Velocity Plus deck design enhances airflow for superior cutting quality, resulting in cleaner cuts and better grass dispersal.

Powered by a robust 25 HP Kohler Command Pro engine, both models deliver the necessary power to tackle tough mowing jobs with ease. The engine's exceptional torque and performance ensure that even thick grass doesn't slow these machines down. Additionally, the Kohler engine is designed for improved fuel efficiency, helping operators save on fuel costs during long hours of operation.

One of the standout features of the STT52V-25CH-LP and STT61V-25CH-LP is their advanced hydrostatic transmission, providing smooth and responsive speed control. Operators can effortlessly adjust their speed and direction, making it easy to navigate tight spaces and uneven terrain. The ergonomic operator platform enhances comfort, with padded seats and adjustable armrests allowing for extended periods of mowing without fatigue.

Both models come equipped with a heavy-duty, commercial-grade transmission, capable of withstanding the rigors of daily use in demanding conditions. Additionally, they feature an intuitive control panel, allowing users to easily monitor important metrics, such as fuel levels and hour meters.

For added convenience, these mowers incorporate an easy-access maintenance design, allowing for quick inspections and routine servicing. With a focus on user-friendliness, Scag has ensured that operators can maintain their equipment with minimal downtime.

In summary, the STT52V-25CH-LP and STT61V-25CH-LP from Scag Power Equipment offer a compelling combination of power, performance, and user-friendly features. Ideal for commercial landscapers and serious gardening enthusiasts alike, these mowers stand ready to deliver exceptional results in any mowing environment.
Top Page Image Contents