Scag Power Equipment STT61V-25KBD-SS manual Roll-over protection system

R

Section 2

2.5 Roll-over protection system

WARNING

Keep the roll bar in the raised and locked position and the seat belt securely fastened during operation. Failure to do so could cause serious injury or loss of life.

This mower has been designed for good traction and stability under normal mowing conditions. However, caution must be used when traveling on slopes, especially when the grass is wet. Do not mow on wet grass. Wet grass reduces traction and steering control.

Any or all parts of the Roll-Over Protection System MUST NOT be removed. Failure to adhere to this guideline could result in injury or death.

WARNING

There is no roll-over protection when the roll bar is in the down position.

Lower the roll bar only when absolutely necessary.

Raise the roll bar as soon as clearance permits.

DO NOT wear the seat belt when the roll bar is in the down position.

Lower the roll bar only when absolutely necessary.

1.To lower the roll bar, loosen the tension knob on both the left hand and right hand bar. See Figure 2-1.

2.Remove the hairpin cotter pins and remove the two

(2) lock pins. See Figure 2-2.

3.Lower the roll bar to the down position.

4.To raise the roll bar, lift the bar to the upright position.

5.Install the two (2) lock pins through the hole, secure with the two (2) hairpin cotter pins and tighten the tension knobs. See Figure 2-2.

UPRIGHT AND

LOCKED POSITION

TENSION

KNOBS

Figure 2-1. Foldable Roll-Over Protection System

HAIR PIN

ALWAYS wear seat belt when roll bar is in the up position.

Operate the machine smoothly, no sudden turns, starts or stops.

LOCK PIN

TENSION KNOB

Check the area carefully before mowing for proper overhead clearance (i.e. branches, doorways, etc.).

DO NOT contact any overhead object with the roll bar.

Figure 2-2. ROPS Hinge

The potential exposure of the seat belt to severe environmental conditions make it crucial to inspect the seat belt system regularly.

6