Rover Mowers Limited | Rotary Lawnmower |
2.2Removing the Grass Catcher (Refer Fig 3.)
1.Grasp the grass catcher by the top handle and lift up.
2.Raise the rear flap of the mower while lifting the grass catcher (this will release the grass catcher).
3.Lift the grass catcher clear of the mower.
4.Lower the rear flap.
2.3Adjusting the Height of the Cut
(Refer Fig. 4)
1. Grasp the Cut Height Lever. (A)
Figure 4 - Adjusting the Height of the Cut
2.Apply an outward pressure to release the Cut Height Lever from the rack.
3.Hold the lever out.
4.Move the lever up or down the rack for suitable height of cut.
5.Engage the lever in the adjustment rack.
6.Release the lever.
2.4To Start the Engine
ENGINE WITH PRIMER BULB
1.Move the throttle control to FAST position.
2.Prime engine as per engine manual.
3.Grasp the starter handle and pull.
ENGINE WITH MANUAL CHOKE
1.Turn fuel tap ON. (where fitted).
2.Move throttle control to CHOKE position.
3.Grasp starter handle and pull.
4.After engine starts move throttle control to FAST position.
2.5To Stop the Engine
1.Move the Throttle Control lever to the STOP position. 
2.6Self-Propelled Mowers - Engaging the Drive
1.Start the engine and move the throttle control to the FAST position.
2.Push slowly forward on the clutch engagement lever to engage the self- propelled drive to the rear wheels.
2.7Self-Propelled Mowers - Disengaging the Drive
1.Release the clutch engagement lever.
2.Allow the clutch engagement lever to return to the disengaged position.
CAUTION
To avoid excessive clutch wear. Do not hold the engagement lever in a
3. MAINTENANCE - General
CAUTION
•Do not allow dirt to enter the air tube, engine damage may occur.
•Check the condition of the air tube regularly and replace if damaged.
3.1Engine Air Cleaner
(Refer to the Engine Manufacturer’s Instructions for detailed cleaning instructions)
The engine air cleaner element must be serviced after each 25 hours of normal mowing. The element must be serviced more regularly if the mower is used in dusty conditions.
3.2Snorkel Air Cleaner (Refer Fig. 5)
Where Fitted
The snorkel air cleaner element must be serviced after each 50 hours of normal mowing. The element must be serviced more regularly if the mower is used in dusty conditions. Replace immediately if the element is damaged.
1.Disconnect the air tube from the element holder.
2.Remove the holder cap.
3.Remove the cartridge and tap gently on a flat surface to remove dirt.
4.Replace element in holder and replace holder cap.
5.Replace the air tube to the bottom of the element holder.
Page 2