Infinity 108IL10B, 108IL30B, 108IL40C, 108IL10C, 108IL40B, 108IL30C Installing Feet, IL30 and IL40

INSTALLING FEET

IL30 and IL40

Refer to Figure 3 as you perform the following steps:

1.Open each accessory pack and locate the following items: four feet (with spike/round ends), four locking nuts, four nylon domes and one wrench.

2.Lay each speaker on its side and locate the four threaded holes on the bottom.

3.For carpets, screw the round end of a foot into each hole and hand-tighten a nut onto each one. Leave a minimum of 5/8" of exposed spike. (On thicker carpets, you can increase the length of exposed spike up to 1-1/8"). For hard-surface floors, screw the spike end into each hole instead and leave 5/8" of round end exposed.

4.Carefully flip each speaker upright to sit on its feet.

5.If needed, adjust the feet so each speaker is level and then tighten each nut with the enclosed wrench. To protect hard surfaces (e.g., wood floors), slip a nylon dome onto each round end.

Bottom

of Speaker

Locking Nut

5 ⁄8" min.	5	⁄8"
	Foot

11 ⁄8" max.

round end

spike end

Nylon Dome

(optional for wood floors)

CARPETED	HARD-SURFACE
FLOORS	FLOORS

FIGURE 3 – This cross section shows how to install a foot onto the bottom of an IL30 or IL40 floorstanding speaker.

INTERLUDE 3