Fitting Instructions 30 Teasing Rake | Rover 300361, 300433 specification

LUBRICATION – Pre-lubricate, sealed ball races are fitted to the cutter, drum shaft, countershaft and front roller. No further lubrication is necessary to these 8 races.

Drums are fitted with special self-lubricating bushes and do not require lubrication. Driving Chains – grease or medium oil used sparingly.

Gear Box – use medium oil at points B, C and D. Use grease sparingly on gear teeth.

FRONT ROLLER SCRAPER – Loosen clamp bolt each end, adjust scraper to just clear the roller and re-tighten clamps.

CLEANING – This mower is constructed of first-class materials, and will give longer and more efficient service if kept clean. After cutting and before putting machine away, wipe blades down with an oily rag. Occasionally check nuts and bolts for tightness.

WARNING – State Electricity Authority regulations provide that it is always necessary to disconnect power supply before effecting any adjustments to the machine.

ELECTRIC MOTOR

MODEL 300361 1.5 HP 240V SINGLE PHASE 7.3 AMPS.

MODEL 300433 1.5 HP 415V THREE PHASE 2.6 AMPS.

NOTE: Model No: 300361 QueenTM mower is fitted with a manual reset overload switch. The reset button is located on the mains power switch mounted on the right hand side of the handles.

FITTING INSTRUCTIONS 30” TEASING RAKE

1. Remove front	roller	2. This allows front roller	3. Remove spacer tube from	4. Replace	bottom	spacer
quadrant bolts and	nuts	assembly, complete with	roller assembly by tapping	tube with	teasing	rake
(A and B), and also roller		bottom spacer tube to be	off quadrant from the roller	assembly with rake sections
adjusting rod nut (C) at both		removed clear of machine.	ball race.	facing frontwards.
sides of the mower.

7. Adjust teasing rake depth so that it is just able to tease up the runners. Adjustment is effected by loosening bolt

5.The quadrant bolt “A”, 6. Re-adjust front roller to “A” each side and adjusting the rake height as required. To

must enter the square hole	desired height	of	cut (as	raise, unscrew nut “B” and take up with slack “C”. Retighten
in the rake supporting plate	described in	the	mower	“A”. Reverse procedure to lower rake.
“B”, before re-assembly to	instruction manual).
the mower.