ASSEMBLY
HOW TO INSTALL THE FRONT WHEELS
Use a knife and cut the four sides of the container. Install the front wheels in the container.
NOTE: Use a piece of wood about 4 feet (1.25 meters) long to raise the front of the tractor. If a piece of wood cannot be found, get another person to help lift the tractor. Be careful, do not let the tractor fall.
1.Raise the front of the tractor. Set a support (block of wood) under the tractor.
2.Make sure the valve stem is to the outside of the tractor. Slide the front wheel on the spindle.
3.Fasten each front wheel with washer, washer and cotter pin. Bend the ends of the cotter pin appart to keep the front wheel on the spindle.
4.After the front wheels are installed, lift the tractor from the support. Roll the tractor off of the container.
5.If your tractor has hub caps, install the hub caps. Make sure the washers hold the hub caps in place.
Cotter Pin
Washer (17x195)
Washer (17x192)
Hub Cap 
A |
Spindle
Black Cable
Valve Stem | Front Wheel |
|
Figure 1
F 050758L | 11 |