MAINTENANCE
INSTALLATION
1.Slide the motion drive belt between the stack pulley and the belt guides (Figure 30). Install the motion drive belt on the top pulley of the stack pulley. Make sure the V side of the belt is against the pulley.
2.Push the motion drive belt through the opening between the steering plate and the engine plate.
3.Install the end of themotion drive belt around the drive pulley (Figure 27).
4.Tighten the belt guides at the drive pulley (Figure 28).
5.Put the belt around the idler pulley (Figure 27, Figure 32). Assemble the idler pulley. Fasten the idler pulley with the hex nut. Make sure the flat side of the belt is against the idler pulley. Also, make sure the belt is not twisted.
6.Make sure the motion drive belt is inside all the belt guides (Figure 27, Figure 28).
7.Attach the adjuster nut and shift link to the adjuster bracket with a hair pin (Figure 29). See How To Adjust The Shift Lever.
8.Attach the steering shaft assembly to the steering plate with two screws (Figure 31).
9.Attach the access panel (Figure 31).
10.Check the routing of the motion drive belt. Make sure the motion drive belt is installed correctly on the idler pulley. Make sure the steering shaft assembly in inside the motion drive belt (Figure 32).
11.Install the battery.
12.Before you use the unit, check the adjustment of the clutch. See the instructions How To Check And Adjust The Clutch.
13.Install the mower housing. See the instructions How To Install The Mower Housing.
Stack Pulley
Steering Shaft
Assembly
Motion Drive |
Belt |
Idler Pulley |
Figure 32
F 050758L | 30 |